Millbank DPM908, DPM904, DPM900 Installation Manual

DESK PAGING MICROPHONES

________________________________________

INSTALLATION GUIDE

Publication Code DPM_TIG Issue 1

DPM900 DPM904 DPM908

PLEASE NOTE: THIS MANUAL AND THE NOTES CONTAINED HEREIN, IS COPYRIGHT AND

MAY NOT BE REPRODUCED EITHER WHOLLY OR IN PART, IN ANY WAY WHATSOEVER,

WITHOUT WRITTEN CONSENT OF MILLBANK ELECTRONICS.

PUBLICATION OF THIS INFORMATION DOES NOT IMPLY ANY AUTHORITY OR LICENCE FOR

THE UTILISATION IN ANY MANNER, IN ANY COUNTRY, OR ANY PATENTED OR REGISTERED

DESIGN FEATURES, MECHANICAL, ELECTRICAL OR AESTHETIC.

 MILLBANK ELECTRONICS

Millbank House, Charter Way, Hurdsfield Industrial Estate, Macclesfield, Cheshire, SK10 1ME, England

TEL: [phone]  FAX: [phone]  e-mail: [e-mail]

In the interest of product improvement we reserve the right to change specification or design without notice.

Designed & Manufactured in the UK by

Millbank Electronics

Millbank Electronics Quality System is Registered by Lloyds

Millbank Electronics operate a Quality Management

System which meets the requirements of

BS EN ISO 9001 : 2000

Product Compliance to EC directives for Standard Products

All standard products conform to the relevant directives,

regulations and standards for electronic and associated apparatus.

The equipment is CE marked both on the apparatus and the packaging.

The Modular range of products for use in Mainframes must be used

in the configuration as described in the product literature.

Failure to use the modular products in the manner described

will invalidate the EC Compliance.

Our products meet the appropriate British and International standards. A product “Declaration of Conformity” Statement is

available for each of the product ranges (available on request). This covers both the EMC and Low Voltage Directives.

UNPACKING

While all Millbank equipment is carefully packed to prevent damage in transit, we recommend that the

equipment is unpacked and inspected immediately on receipt. If damage has occurred

please advise your carrier and your supplier who will arrange appropriate action.

If it is necessary to re-pack the equipment for onward shipping or returning to Millbank for service

PLEASE ENSURE THAT THE ORIGINAL PACKING OR EQUIVALENT IS USED.

KEEP THIS INFORMATION IN A SAFE PLACE

Equipment Serial No...........................................................

Supplied by.........................................................................

............................................................................................

Date.....................................................................................

Publication Code DPM_TIG Issue 1 Page 2 of 6