Page 1
INSTALLATION INSTRUCTIONS
Lower Component Shelf
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
FCS100
Page 2
FCS100 Installation Instructions
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the FCS100 does not exceed
20 lbs (9.1 kg).
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
2
Page 3
Installation Instructions FCS100
88.90
3.5
25.66
3.5
19.53
496.12
289.16
13.18
.61
15.59
53.46
2.10
19.0
482.90
DIMENSIONS
457.20
18.00
88.90
95.25
3.75
137.23
5.40
40.76
1.60
11.38
CENTERLINE OF
MOUNT
651.70
638.48
25.1
334.71
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
3
Page 4
FCS100 Installation Instructions
TOOLS REQUIRED FOR INSTALLATION
#2
PARTS
C (1)
A (1)
B (1)
D (4)
10-24 x 5/8"
E (2)
10-24 x 1"
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
4
Page 5
Installation Instructions FCS100
Assembly and Installation
Assembling Shelf and Brackets
1. Attach lower shelf (B) to hanger bracket (A) using four
10-24 x 5/8" Phillips pan head screws (D). (See Figure 1)
(A)
(B)
(C)
[Display shown removed for clarity]
Wall Mount
Figure 2
1
(D) x 4
Figure 1
Attaching to Wall Mount
NOTE: The FCS100 may be attached to the wall mount with
the display already in place, or with the display
removed. Proceed to either Installing to Wall Mount
with Display Attached or Installing to Wall Mount
with Display Removed section.
Installing to Wall Mount with Display Attached
1. Pull out bottom of display.
2. From below and behind the display, raise and hang hook
bracket (C) onto lower wall mount rail. (See Figure 2)
3. Hang shelf with hanger bracket onto the hook bracket (C).
(See Figure 3)
NOTE: The shelf with hanger bracket may be adjusted up or
down on the hook bracket (C) in 7/8" increments for a
total height adjustment of up to 6-1/8".
(C)
3
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
Figure 3
5
Page 6
FCS100 Installation Instructions
Installing to Wall Mount with Display Removed
NOTE: Installing the FCS100 to a wall mount where a display
has been removed allows use of security screws to
prevent the FCS100 from being removed.
1. Hang shelf with hanger bracket onto the hook bracket (C).
(See Figure 4)
(C)
1
Shelf with
hanger
bracket
Figure 4
NOTE: The shelf with hanger bracket may be adjusted up or
down on the hook bracket (C) in 7/8" increments for a
total height adjustment of up to 6-1/8".
2. Remove display if already attached to wall mount following
instructions included with the wall mount.
3. Hang FCS100 on wall mount rail.
4. Adjust location and secure to wall mount rail using two
10-24 x 1" Phillips pan head screws (E). (See Figure 5)
5. Hang display on wall mount following installation
instructions included with the wall mount.
4
(E) x 2
Figure 5
Routing Cable
1. Place accessory on component shelf.
2. Route cable from accessory up and behind FCS100. (See
Figure 6)
Routing Cable
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
6
Figure 6
Page 7
FCS100 Installation Instructions
Ergo In Demand, Inc.
4900 Industry Drive
Central Point, OR 97502
Contact Information:
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
info@ergoindemand.com (Email)
01/09
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Room 24F, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 9226
F +86-755-8996 9217
Loading...