Milestone Da-Lite Slimline Electrol Instruction Manual

INSTRUCTION BOOK FOR

Slimline Electrol®

Original Instructions

Disclaimer

Milestone and its ailiated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete.
However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide
for every possible contingency in connection with the installation or use of this subject to change without notice or obligation of any
kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone
assumes no responsibility for accuracy, completeness or suiciency of the information contained in this document.

Da-Lite® is a registered trademark of Milestone AV Technologies. All rights reserved.

Important Safety Instructions

When using your video equipment, basic safety precautions should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.

Save These Instructions

Operating Instructions

3Position Switch
Complete with cable,
is standard with the
Slimline Electrol.

4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by the
manufacturer may cause a risk of ire, electric shock, or injury to
persons.

To Lower Screen Surface

Press lower end of slide switch. Screen will stop in the “DOWN”
position automatically.

To Raise Screen Surface

Press upper end of slide switch. Screen will stop in the “UP”
position automatically.

2

To Stop Screen

Screen may be stopped in any intermediate position by
positioning slide switch to center “OFF” position.

NOTE: It is suggested that when screen is not in use, the slide
switch should be positioned to center “OFF” position.

Suggested Methods of Installation

Wall Mounting

Slip hanger
eyes over
screws well
secured in wall.

Ceiling
Mounting

Place “D” rings
over hooks well
secured in ceiling.

Picture
Surface

Picture
Surface

Picture
Surface

Wall Bracket

Use No. 6
brackets to
hang from
beam or
valance

Picture
Surface

Concealed

Allow room for access

3

Conditions for Transportation and Storage

• Temperature: Between 40 - 100F (5 - 40C)

• Relative Humidity: 30% to 70%, non-condensing

• Always keep the projection screen horizontal during transport

• Make sure the entire package is supported when stored

• Do not stack more than six projection screens on top of each other

• Make sure the heaviest package is places at the bottom of the stack

and storage

Screen surface should be allowed to air out once every two months, or otherwise used on a regular basis, if the temperature is above
72F (22C) and at least once every month if the temperature goes above 85F (30C).

LIMITED FIVE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS

Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in
materials and workmanship for a period of ive (5) years from the date of purchase by the original purchaser; provided they are properly
operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the
factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered
with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.
Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,
transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,

or merchantability, that may be mandated by statute or rule of law are limited to the ive (5) year warranty period. This warranty gives
you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED

BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION
OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Customer Care Specialists at
3100 North Detroit Street, Warsaw, IN 46582, (574) 2678101, (800) 6223737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS
WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

FOR YOUR IMAGE | legrandav.com

USA P 866.977.3901 E [e-mail]
CANADA P 877.345.4329 E [e-mail]
EMEA P [phone] E [e-mail]
APAC P [phone] E [e-mail]

In British Columbia, Milestone AV Technologies ULC carries on business as MAVT Milestone AV Technologies ULC .

©2018 Milestone AV Technologies. DL0112 (Rev. 4) 7/18 Da-Lite is a registered trademark of Milestone AV Technologies.
All other brand names or marks are used for identiication purposes and are trademarks of their respective owners. All
patents are protected under existing designations Other patents pending.

22802