Miles Industries G3, 765 Installation Instructions Manual

LEGEND G3

765 Contemporary Surround

CSA approved for use with Valor Models 739 Heaters ONLY

NOT COMPATIBLE with Models 738 Heaters

Installation Instructions

INSTALLER

!

A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed
for the protection of children and other at-risk individuals.

The 765 Contemporary Surround, available in black
(765CSB), copper (765CSC), nickel (765CSN), patina
(765CSP) and vintage (765CSV).

It is intended to be used with the three-sided 756
Square Trim and 764 Picture Frame Trim (supplied
separately). However, it is also compatible with other
three-sided surround trims (excluding cast surrounds)
installed on the 739 heaters.

WARNING

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

3-Sided Outer

Surround

Window trim

Leave this manual

with the appliance.

CONSUMER

Retain this manual

for future reference.

Note: This kit must be installed

by a qualifi ed installer, service
agency or gas supplier. These
instructions are to be used in
conjunction with the fi replace
main installation instructions.

739

The Contemporary Surround fi ts within the outer
surround trim and clips onto the standard mounting
brackets supplied with the 739 heaters.

4002399-06

© Copyright Miles Industries Ltd., 2014

Bottom
cover

Trim assembly with
barrier screen

Overview (Heater, 3-sided outer surround sold separately)

Dimensions & Mantel Clearances

21-1/2” (546 mm)

34” (864 mm)

Outer Trim
Supplied
Separately

(

45°

)

12"

(305 mm)

(152 mm)

1"

(25 mm)

6"

45" (1143 mm)

39" (991 mm)

36" (914 mm)

Kit content

Mantel Clearances

Window trim

Bottom
cover (2)

4-sided trim
assembly with
barrier screen

2

Installation on heater

DO NOT TOUCH THE BARRIER SCREEN OR
FIREPLACE WHILE THEY ARE HOT!

Let the

fi replace cool fi rst before cleaning it.

FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
maintenance if it has been removed.

1. Hook the bottom cover to the brackets inside the
outer surround trim already installed on the heater.

2. Hook the window trim to the window frame as
indicated.

Front view—Window
frame with window trim

Rear view, top of
window frame

Slide window
trim tabs
into slots
on window
frame

3. Hook the trim assembly to the brackets inside the
outer surround trim.

Maintenance

WARNING

!

WARNING

DO NOT TOUCH THE BARRIER SCREEN OR
FIREPLACE WHILE THEY ARE HOT!

fi replace cool fi rst before cleaning it.

FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
maintenance if it has been removed.

Let the

window trim

tab

slot

window
frame

To clean the front trim, use mild soap and water. You
can dust the screen with a soft brush. To brush the
back of the screen, simply unhook the front trim.

If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer’s barrier for this
appliance.

To clean the window and ceramics inside the fi rebox,
consult the Owner’s Information section of the
Installation and Owner’s Manual supplied with the
fi replace.

DO NOT CLEAN THE GLASS WINDOW WITH
AMMONIA!

3