MiLAN MIL-L1624MT, MIL-L1624ST, MIL-L1624VF, MIL-L1624SC, MIL-L1624SC-60 User Manual

MIL-L1624XX

One Port Fiber Module

User Guide

(For use in MIL-S1600 and MIL-S2400 switches)

Introduction

This User Guide introduces the 100FX Modules which can be
installed in the front panel of a MIL-S2400 or MIL-S1600 switch.
Each Optional 100FX Module comes with a one-port fiber connector.
The 100FX Modules are designed to extend the distance between
the switch and other devices.

The maximum distance connected by optical fiber is up to 2 Km
(multi-mode fiber) or 60 Km (single-mode fiber). You can regard this
fiber port as the backbone in the networking infrastructure. There are
five types of fiber port connectors including SC, ST, MT-RJ and VF­45 in multi-mode and SC and MT-RJ in single-mode.

Figure 1.

100FX MODULES

Front Panel

The Front Panels of the 100FX Modules include LED-indicators, two
thumbscrews, DIP-switch, and one fiber port. The Front Panels of
the 100FX Modules are shown as below. (Not shown is the MIL­1624MT-60 single-mode module with MT-RJ connectors).

MIL-S1624MT-60 not shown.

100FX Module with SC Connector

Figure 2. 100FX Module with SC Connector

100FX Module with SC single-mode Connector

Figure 3. 100FX Module with SC single-mode Connector

MIL-L1624SC

MIL-L1624SC-60

100FX MODULES

MIL-L1624ST

100FX Module with ST Connector

Figure 4. 100FX Module with ST Connector

100FX Module with MT-RJ Connector

Figure 5. 100FX Module with MT-RJ Connector

100FX Module with VF-45 Connector

Figure 6. 100FX Module with VF-45 Connector

Note : DIP-switch is to set the fiber port for Full-duplex or Half-duplex.

MIL-L1624MT

MIL-L1624VF