Mikrotikls SIA R11E5HAM User Manual

R11e-5HacD

The R11e-5HacD is a miniPCIe format wireless interface that can operate in the 5GHz wireless spectrum. The card features two MMCX antenna
connectors.

Assembly and mounting

The card is a mini PCIe full length format. Unplug the host device from power, and remove the preinstalled screws from the two locations where
the card will be inserted. Insert the card at a slight angle, with the connector end first, push it slightly, so that it clicks into place. Lower the card
until it is parallel to the motherboard and then use the two screws to fasten it in place. Attach the antenna to the card antenna connectors.

Configuration

The device will be automatically recognized when used in a RouterOS powered device. Configuration can be set in the “Wireless” menu. More
information about using RouterOS can be found in our documentation: http://mt.lv/help

Operating system support

The device is tested with RouterOS v6 and above. It might be compatible with other operating systems, but drivers are not included with the
card.

List of approved antennas for 5GHz:

• Omni Directional, MT-482016/N/A, 9 dBi;

• Panel, PA58-24-ANT, 24dBi;

See www.routerboard.com for more information. Contact [e-mail] 29-Jan-19

Federal Communication Commission Interference Statement

(FCC ID: TV7R11E5HAM)

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

This device and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter.

IMPORTANT: Exposure to Radio Frequency Radiation.

0,29m minimum distance has to be maintained between the antenna and the occupational user and
0,64m to general public. Under such configuration, the FCC radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied.

List of approved antennas for 5GHz:

• Omni Directional, MT-482016/N/A, 9 dBi;

• Panel, PA58-24-ANT, 24dBi;

Antenna Installation. WARNING: It is installer's responsibility to ensure that when using the
authorized antennas in the United States (or where FCC rules apply); only those antennas certified
with the product are used. The use of any antenna other than those certified with the product is
expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the
output power level of antennas, according to country regulations and per antenna type.

Professional installation

is required of equipment with connectors to ensure compliance with health and safety issues.

See www.routerboard.com for more information. Contact [e-mail] 29-Jan-19