Mikrotikls SIA LR9 User Manual
R11e-LoRa9
R11e-LoRa9 - LoRa mPCIe Gateway module. Can be integrated into RouterBOARD product with mPCIe slot.
Requires LoRa package installation to configure in RouterOS.
Specifications
Low power-consuming with mini PCIe interface, for long-distance data transmit.
• Interface - Mini-PCIe
• Temperature Operating -40 / +70
• Supports Class A,B and C
• Frequency - 902-928MHz (US)
• RF Output power - 902-928MHz (US)
• Range 10km (@ 980bps) Depends on the antenna used.
Installing the module in your device
R11e-LoRa9 for professional use. Each of the cards comes in ESD protective packaging. When handling electrical
equipment please observe the following safety precautions:
• Use a wrist grounding strap when unpacking and working with electrical components to avoid electrical
discharge (ESD) damage.
• After unpacking please place the card on the anti-static mat.
• When installing make sure there are no objects that can damage or touch the PCB plate.
• The card can be installed in your desired device using the factory provided screw holes in a PCB plate.
Pictures added for illustration purposes, the device configuration and the placement of the miniPCIe card may vary.
• Locate miniPCIe slot on your device.
• Unscrew two factory attached screws.
• Place thermal pad to the heat sink plate.
See mikrotik.com/products for the latest version of this document. Page 1, Document #51982 Modified on: 10.SEP.2019
• Install module to the miniPCIe slot and secure with previously removed screws. Tightening torque 0,3 Nm.
Connecting to the antenna
If your device does not have internal antennas, it is possible to connect to the external antennas by adding
cable connectors, product code – ACSMAUFL. https://mikrotik.com/product/acsmaufl
Please connect and disconnect the antenna, when the device is turned off!
• Attach antenna cables to the installed module.
When installing outdoors please ensure that the device case is waterproof and are designed for outdoor
use. The IP rating scale for this device is IP0.
Mounting and configuration of this device should be done by a qualified person.
See mikrotik.com/products for the latest version of this document. Page 2, Document #51982 Modified on: 10.SEP.2019
Loading...