R11e-LTE6 is a standard Mini PCIe module,supports LTE for next-generation cellular networks and
R11e-LTE6
provides high speed and reliable mobile broadband data connection.LTE data rate can achieve DL 300Mbps/DL
50Mbps.
The rich of interfaces and RF bands allow it to be widely used in CPE, industrial routers, security monitoring,
IOT and other applications.
General Features
•CA(FDD): B1+B5,B1+B8,B1+B20,B2+B5,B2+B17,B3+B5,B3+B7,
B3+B8,B3+B20,B7+B8,B7+B12,B7+B20,B8+B1,B20+B1,
B5+B2,B12+B2,B5+B3,B7+B3,B8+B3,B20+B3,B20+B7,
•CA(TDD): B38+B38,B39+B39,B40+B40,B41+41,B39+B41 • WCDMA PS: DL 384 kbps/UL 384 kbps
•LTE(FDD): Band 1/2/3/5/7/8/12/20/25/26 • HSPA+: DL 21.6 Mbps/UL 5.76 Mbps
•LTE(TDD): Band 38/39/40/41 • DC-HSPA+: DL 42 Mbps/UL 5.76 Mbps
•UMTS:Band 1/2/5/8 • GPRS: DL 107 kbps/UL 85.6 kbps
•E'WZ^/
B1+B1,B2+B2,B3+B3,B5+B5,B7+B7,B8+B8,B12+B12
GPRS/GSM:Band 2/3/5/8 • E'WZ^: DL 296 bps/UL 236.8 kbps
Data Features
• CA FDD :Category 6, DL 300Mbps UL 50Mbps
• CA TDD: Category 6, DL 224Mbps UL 10Mbps
• WCDMA CS: DL 64 kbps/UL 64 kbps
•MIMO: 2*2 and 4*2 DL
Interfaces
•Environmental
Operating Temperature: -20℃～+70℃
Extreme working temperature:-40℃～+80℃
Humidity: 5%～95%
•Power Supply:
3.8V)
•Dimensions:
•AT Command:
•OS:
Windows/Linux/Android
3.2 V to 4.2V (typical:
51mm * 30mm * 5.0mm
3GPP TS 27.007 and 27.005
RF Parameters
•Output Power
LTE: 23dBm±2dB (3GPP TS 36.101 R9 Class 3)
UMTS: 24dBm+1/-3dB (Power Class 3)
EGPRS 1800/1900MHz: 26dBm+3/-4dB (Power Class E2)
EGPRS 850/900MHz: 27dBm±3dB (Power Class E2)
GSM/GPRS 1800/1900MHz: 30dBm±2dB (Power Class 1)
GSM/GPRS 850/900MHz: 33dBm±2dB (Power Class 4)
•Sensitivity
• Mini PCIe interface
• USB 2.0 x1
• SIM Card x1
• IIC Interface x1
• PCM Interface x1
• LED
• RESET
• Antenna interface
FDD LTE:-99 dBm(10MHZ)
TDD LTE:-97 dBm(20MHZ)
GSM 850/900 MHz: -109 dBm
GSM 1800/1900 MHz: -110 dBm
WCDMA 850/1900 MHz: -110 dBm
WCDMA 900/2100 MHz: -110 dBm
Certific
• FCC*(North Americal)
• CE*(Europe)
• IC*(Canada)
EU Regulatory RED Declaration of Conformance
Hereby, we(Mikrotikls SIA) declared that this device is in compliance with the essential requirements and other relevant provisions of Directive
2014/53/EU
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
can radiate radio frequency energy and, if not installed and used in accordance with
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television
interference by one or more of the following measures:
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
the FCC Rules.
equipment
generates, uses and
the instructions, may cause harmful interference to radio
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device
not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and
operated with a minimum distance of 20 centimeters between the radiator and your body.
Les antennes installées doivent être situées de facon à ce que la population ne puisse y être exposée à une distance de moin de 20 cm. Installer les
antennes de facon à ce que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’ antenne.
CAN ICES-3(B)/NMB-3(B)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
doit pas produire de brouillage;(2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en
suivantes : (1)L’appareil ne
compromettre le fonctionnement.
CAN ICES-3(B)/NMB-3(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:(1)This device may not cause interference.(2)This device must
accept any interference,
including interference that may cause undesired operation of the device.
The host will Satisfy Class I or Class Ⅱ permissive change based this module FCC ID.If the identification number is not visible when the module is installed
inside the host, thenthe outside of the device into which the module is installed must also display a label referring tothe enclosed module. This exterior
label can use wording such as the following: “ContainsTransmitter Module Contains FCC ID:TV7R11ELTE6 or “Contains FCC ID:
TV7R11ELTE6 .Any similar wording thatexpresses the same meaning may be used.
Loading...