MikroTik nRAYG-60adpair User manual

1.

2.

3.

nRAY series

Wireless Wire nRAY (nRAYG-60adpair)

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be mounted on a pole. Please read the wall mounting instructions carefully before beginning installation. Failure to use the correct
hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
Read the installation instructions before connecting the system to the power source.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

Quickstart

Please follow these quick steps to set up your device:

Unscrew the cover to reach Ethernet port;
Guide Ethernet cable trough opening;
Plug into the Ethernet port and screw clockwise tightly, to ensure water protection;
Connect the PoE injector into the computer;
Connect the power adapter to the PoE injector;
Download WinBox configuration tool ;https://mt.lv/winbox
Default IP: 192.168.88.1, user name: and there is no password, for the paired models, please find the password on the sticker;

admin

Once connected, configure the device, so it has an active Internet connection ;https://mt.lv/configuration
Upgrade the RouterOS software to the latest version ;https://mt.lv/upgrade
Connect again and choose your country on the left side of the screen, to apply country regulation settings;
Set up your router password in the bottom field, to the right and repeat it, it will be used to login next time.

Powering

The device accepts power 802.3af/at PoE in 12 – 57 V DC .
The power consumption under maximum load can reach 6 W.
Connecting to a PoE Adapter:

Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.

Mounting

1.

2.

3.

The device is designed to be used outdoors and mounted on the pole.
When mounting, please ensure that cable feed is pointing downwards.
The IP rating scale of this device is IP54. We recommend using Cat6 shielded cables.
Warning! This equipment should be installed and operated with a minimum distance of 60 cm between the device and your body. Operation of this
equipment in the residential environment could cause radio interference.

Mounting and configuration of this device should be done by a qualified person.

Assemble the device with mounting bracket.

Use M5 screws to fix the mounting bracket, tighten with the HEX3 tool.
Insert U bolt. In the sequence as it is shown in the picture.

4.

5.

Attach the assembly to the pole.

Add mount bracket and use two 13 mm nuts to secure the device.

Aim tool usage

Grounding