mikroElektronika mikroETH 100 User Manual

Page 1
mikroETH 100
All Mikroelektronika’s development systems feature a large number of peripheral modules expanding microcontroller’s range of application and making the process of program testing easier. In addition to these modules, it is also possible to use numerous additional modules linked to the development system through the I/O port connectors. Some of these additional modules can operate as stand-alone devices without being connected to the microcontroller.
Manual
Additional Board
MikroElektronika
Page 2
mikroETH 100
The mikroETH 100 additional board is used to connect the microcontroller installed in some device to the Ethernet network.
Key features:
- IEEE 802.3™ Compliant Fast Ethernet Controller;
- Integrated MAC and 10/100Base-T PHY;
- Hardware Security Acceleration Engines;
- 24-Kbyte Transmit/Receive Packet Buffer SRAM;
- Operating voltage range of 3.0V to 3.6V; etc.
Figure 1: mikroETH 100 with mode 5 activated
How to connect the board?
The mikroETH 100 additional board is connected to the microcontroller in some device via pads CN1 and CN2. Connection with the Ethernet network is established via the RJ45 connector. Jumpers J1-J4 are used to select PSP mode (Parallel Slave Port interface), table 1.
Position of jumpers J1-J4
PSP MODE 1 0 OFF
1 PSPCFG2, PSPCFG3, PSPCFG4 PSPCFG1
2 PSPCFG4 PSPCFG2, PSPCFG3 PSPCFG1
3 PSPCFG2 PSPCFG3, PSPCFG4 PSPCFG1
4 PSPCFG2, PSPCFG4 PSPCFG3 PSPCFG1
5 PSPCFG3 PSPCFG1, PSPCFG2 PSPCFG4
6 PSPCFG1, PSPCFG3 PSPCFG2 PSPCFG4
9 PSPCFG2, PSPCFG3 PSPCFG1 PSPCFG4
10 PSPCFG1, PSPCFG2, PSPCFG3 PSPCFG4
Table 1
MikroElektronika
Page 3
PSP MODE
#Pins
min max
Data
Width
Address/Data
Multiplexing
Control lines Theoretical
1 19 26 8 bit No CS, RD, WR 80
2 19 26 8 bit No CS, EN, R/W 80
3 26 34 16 bit No CS, RD, WRL, WRH 160
4 26 34 16 bit No CS, R/W, B0SEL, B1SEL 160
5 12 19 8 bit Yes AL, CS, RD, WR <80
6 12 19 8 bit Yes AL, CS, EN, R/W <80
9 19 21 16 bit Yes AL, CS, RD, WRL, WRH <80
10 19 21 16 bit Yes AL, CS, R/W, B0SEL,
B1SEL
Table 2
Performance @
10MHz (Mbits/s)
<80
Figure 2: mikroETH 100 additional board connection schematic
MikroElektronika
Page 4
Figure 3: Dimensions of the mikroETH 100 additional board
Figure 4: mikroETH 100 connected to the Ethernet cable
MikroElektronika
Page 5
MikroElektronika
Page 6
MikroElektronika
If you want to learn more about our products, please visit our website at www.mikroe.com
If you are experiencing some problems with any of our products or just need additional information, please place your ticket at
www.mikroe.com/en/support
If you have any questions, comments or business proposals, do not hesitate to contact us at ofce@mikroe.com
Loading...