mikroElektronika Audio Codec Proto User Manual

Page 1
AUDIO CODEC PROTO
All Mikroelektronika’s development systems feature a large number of peripheral modules expanding microcontroller’s range of application and making the process of program testing easier. In addition to these modules, it is also possible to use numerous additional modules linked to the development system through the I/O port connectors. Some of these additional modules can operate as stand-alone devices without being connected to the microcontroller.
Manual
Additional board
Page 2
AUDIO CODEC PROTO
The AUDIO CODEC PROTO additional board enables the microcontroller to be connected to a microphone and headphones via I2C and SPI serial communications.
Key features:
- Stereo CODEC;
- Driver for earphones;
- Low power consumption;
- 3.3V power supply voltage.
Figure 1: AUDIO CODEC PROTO
How to connect the board?
The additional board is connected to a microcontroller via pads CN2. A 3.5mm connector CN23 is used to connect a microphone, whereas the CN22 connector is used to connect earphones.
How to use the board?
The board is used to convert digital audio recording into analog audio signal that is reproduced via headphones. It is also used to convert analog audio signal from microphone into digital audio recording. Data transfer between the microcontroller and additional board is performed via the Serial Peripheral Interface (SPI), whereas the operation of the board is controlled by the microcontroller via I2C communication.
MikroElektronika
Page 3
Figure 2: AUDIO CODEC PROTO additional board connection schematic
The function of pins:
SCK - Digital Audio Bit Clock, Pull Down MISO - ADC Digital Audio Data Output MOSI - DAC Digital Audio Data Input ADCL - ADC Sample Rate Left/Right Clock, Pull Down DACL - DAC Sample Rate Left/Right Clock, Pull Down SDA - 3-Wire MPU Data Input / 2-Wire MPU Data Input SCL - 3-Wire MPU Clock Input / 2-Wire MPU Clock Input
Figure 3: Dimensions of the additional board
NOTE: Pull up/pull down is only present when Control Register Interface is ACTIVE=0 in order to save power.
MikroElektronika
Page 4
MikroElektronika
If you want to learn more about our products, please visit our website at www.mikroe.com
If you are experiencing some problems with any of our products or just need additional information, please place your ticket at
www.mikroe.com/en/support
,I\RXKDYHDQ\TXHVWLRQVFRPPHQWVRUEXVLQHVVSURSRVDOVGRQRWKHVLWDWHWRFRQWDFWXVDWRI¿FH#PLNURHFRP
Loading...