Migatronic ZETA 60, ZETA 100 Quick Manual

50113777

QUICKGUIDE

ZETA 60 I 100

UK

10A 30A 45A 60A

0 5 10 15 20

0.9

1.0

1.1

1.2

10A 30A 45A 60A 75A 85A 100A

0 5 101520253035

0.9

1.0

1.1

1.2

1.4

1.5

1.6

Expected quality cut
Dividing cut with reduced quality

Zeta 60

Zeta 100

Please regard the table as a guideline for choice of nozzle size/A compared with maximum
plate thickness for cutting in mild steel. In the case of cutting in other materials, the possible
cutting capacity and cutting speed are reduced.

Amperage
setting (A)

Amperage
setting (A)

Nozzle size mm

Nozzle size mm

Plate thickness mm

Plate thickness mm

1 Control knob

Control knob for setting the cutting current:
20-60A for Zeta 60, and
20-100A for Zeta 100.

2 Cutting voltage

The LED shines for safety reasons when
there is voltage on the cutting torch.

3 Overheating

The LED shines if cutting is interrupted due
to overheating of the machine. The machine
will reconnect automatically after a short
cooling period.

4 Mains error

Low voltage.

5 Cutting current

The LED indicates cutting current.

6 Air pressure

The LED shines if the air pressure falls
to below 3 bar. The machine stops
automatically.

7 Torch error

The LED flashes if there is a short circuit in
the torch. The machine stops automatically.
The LED shines if the torch body is assembled
incorrectly. Always turn off the machine
when changing the spare parts. There is a
risk of high voltage and electric chock.

8 Normal cutting

This function should be used in general.

9 ”Grid” cutting

This function should only be used under
special conditions (e.g. cutting in punched
plates or metal grids); Automatic change­over between pilot arc and cutting arc.

10 Plasma gouging (Zeta 100 only)

This function is for gouging out
material/welds.

11 Air pressure test

Zeta 60: The gas valve will open without

igniting the arc. This function allows check
and adjustment of the air pressure on
the gauge positioned on the back of the
machine. The air pressure should be
min. 3.5bar for cutting.
Zeta 100: An electrical detection of
over/under pressure is present and
therefore the meter in the regulator has
been removed. The air pressure should be
min. 3.5 bar for cutting and 2.5 bar for
gouging.

12 A (Zeta 100 only)

Display of arc voltage or cutting current.
The key pad must be pressed for 3 seconds
and the LED next to the “A” indicator
will be turned off, when the arc voltage
is displayed. Repress = return to cutting
current.

QUICKGUIDE ZETA 60 I 100

UK

1

2

3
4

7

869

10

11

5

12