Miele professional PG 8130, PG 8131, PG 8132, PG 8133 Installation Instructions

Installation plan

PG 8130
PG 8131
PG 8132
PG 8133

It is essential to read the operating instructions
and service documents before installation or use
of this appliance. This will prevent both personal
injury and damage to the machine.

en - AU, NZ

M.-Nr. 10 720 840

Installation notes

2 PG 8130 / PG 8131 / PG 8132 / PG 8133

Please read and observe the operating instructions and the
service documents regarding installation and setting up of this
dishwasher.

Installation
requirements

This dishwasher must be installed by a suitably qualified person
with the appropriate electrical and plumbing qualifications in

accordance with the installation instructions supplied.
This dishwasher must be installed in accordance with all applicable
standards and guidelines, including legal requirements and health
and safety regulations.
The machine must be commissioned and operatives trained in its
use by Miele Professional Service or by an authorised Miele Service
Partner only.

Electrical
connection

Connection to the electrical supply must be in accordance with valid
legal requirements, health and safety regulations, and applicable
standards. The mains connection cable must be protected from the
risk of thermal damage.
We recommend connecting the dishwasher to the power supply via a
suitable plug and socket as this will make it easier to carry out the
electrical safety test during commissioning and after any service
work.
For hard-wired dishwashers, connection must be via a main switch
to be provided on site, which must completely isolate the machine
from the power supply with a contact gap of at least 3mm.
The plug, socket, and main switch must be easily accessible once the
dishwasher has been installed.

Equipotential
bonding and
earthing

For added safety, the dishwasher should be protected with a residual
current device with a trip current of 30mA.
Equipotential bonding should be carried out if required. The screw

connection point for equipotential bonding is located at the back of
the dishwasher. Equipotential bonding and earthing must be carried
out before the machine is commissioned.

Water connection

This appliance must be installed according to AS/NZS3500.1. This
appliance has been supplied with a separate backflow prevention
device (non-return valve) and must be connected to the water tap..
The tap for the water supply must be easily accessible.

The dishwasher can be connected to either a cold water or hot water
supply.

Environmental
requirements

Condensate can build up in the area surrounding the dishwasher.

Any cabinetry and fittings in the room must therefore be suitable for
purpose. If the machine is fitted under a suitable worktop (built-under
and integrated models), the stainless steel steam deflector plate
provided must be fitted above the door aperture to protect the
worktop from moisture damage. A matching steam deflector plate is
also available for order at a later date from Miele Professional Service.

Installation notes

PG 8130 / PG 8131 / PG 8132 / PG 8133 3

Connecting an
external
dispensing
system

A dispensing system for liquid detergent and rinse aid can be
connected at the back of the machine.