Midwest Specialties S36, M60 Operation Manual

REV.000

Distributed by Ergonomic Partners

[e-mail]

www.ErgonomicPartners.com

Tel: [phone]

REV.000

REV.000

FLEXARM

REV.000

Limited Warranty

A new FlexArm has a 3 year limited warranty on parts and labor. This warranty does not apply to a
FlexArm determined to have been misused or abused, improperly maintained, or having defects attributed
to the use of non-genuine repair parts.

Original pressure cylinders have a 3 year limited warranty from the date of purchase. When replacing
one of the pressure cylinders, make sure not to scratch, mar, or nick the shaft or tube on either the old
cylinder being replaced or the new cylinder being installed. All warranty cylinders must be returned to
Midwest Specialties for evaluation. The warranty is void if the cylinder to be evaluated shows signs of
scratches or nicks on the cylinder shaft or tube. Damaged cylinders cannot be returned to the
manufacturer for warranty claims. Replacement cylinders carry a limited 1 year warranty from the
date of purchase.

Pneumatic motors have a 3 year limited warranty (warranted to be free of defects in material and
workmanship from the date of purchase). This warranty does not apply to the following (perishable)
components:

- filters - springs

- blades/vanes - O-rings

This warranty is void if it has been determined that the motor was misused, abused or improperly
maintained.
Midwest Specialties is not responsible for a customer’s air quality. We supply the basic tools and offer a
coalescent filter option for those who have experienced excessive moisture and water. The responsibility
for clean, dry air falls upon the individual shop. Any pneumatic motor coming in for evaluation or repair
with rusted components will not get warranty coverage because this is considered improper maintenance.

Once the original warranty expires, repaired Motors and Arms carry a limited 60 day warranty
from the date of the repair.

Tap Holders and Helicoil components are considered perishable tooling and therefore do not carry a
warranty. However, Size 2 through Size 4 Tap Holders may be reworked depending of the severity of the
damage or wear. Please contact Midwest Specialties for a return authorization and the holders can be
evaluated.

The warranty is void if changes to the FlexArm or motor, or attempts to repair it or its components are
made without the expressed authorization of Midwest Specialties Inc.
The warranty is based on normal usage which would be the equivalent of a 40hr work week.

For technical assistance or questions concerning the proper care and maintenance of the FlexArm unit or
the pneumatic/hydraulic motors, please contact Midwest Specialties, Inc. at 800-837-2503.

Revision 7/01/14

REV.000

REV.000

REV.000