MID WEST PRODUCTS B-319NT Owner's Manual

31” DELUXE PUSH PAVEMENT/LEAF/LAWNSWEEPER

MODEL B-319NT

No Tools Required Owner’s Manual and Parts List

SAVE THIS MANUAL

You will need this manual for the safety instructions, assembly instructions and parts list. Put it in a

safe, dry place for future reference.

©2017 Mid West Products, Inc. -1- Form No. M1-1639

1. Lay all parts on a flat surface, and follow these few
simple instructions.

2. Set chassis (36) on its wheels and swing support stand
(31) to rear until ends of stand are against stops in
chassis end plates. It is not necessary to loosen nuts
(12). See figure 3.

3. Remove wing nuts (6) and hook bolts (14) from the
steering handle (30). Slip reduced ends with holes of
side handle tubes (33) into ends of steering handle tube
(30). Line up hole in each end and reinsert hook bolts
(14) through tubes. Secure with wing nuts (6). See
figures (1 and 2) for correct position of all parts. NOTE:

Make certain hook bolt points to rear of sweeper.

4. Now, remove wing nuts (6) from the bottom ends of the
side handle tubes (33). Slip bottom ends of side handle
tubes (33) inside chassis (36) See Figure 8. Make
certain the thumb screws (28) go through the hole in
the formed pocket. Reattach the wing nuts (6) onto the
thumb screws (28) now protruding through the outside
of the chassis (36).

5. Hang hamper (35) inside handle assembly with rear
hamper rod (32) in hooks (14). Place front hamper rod

(32) in slots “Y” of chassis end plates. See figure 2 and

4.

Fasten hangers (5) on side handles. Tilt hanger in—slide
and twist out over tube. See figure 6.

All “right” and “left” directions should be considered

as from your position behind the lawnsweeper

CHASSIS (36)

(The correct positioning of the handle tubes as you are

looking into the brush assembly of the chassis)

FIG 8

Left Side Handle Right Side Handle

Tube Tube

©2017 Mid West Products, Inc. -2- Form No. M1-1639