MID WEST PRODUCTS B-319 Owner's Manual

Created 03-2000 -1- Form No. M1-0005

MID WEST PRODUCTS, INC.

Pavement/Leaf/Lawn Sweeper  31” Model B-319

Owner’s Manual and Parts List

Created 03-2000 -2- Form No. M1-0005

1. Only one adjustable wrench and pliers is required to assemble

your new lawnsweeper. Just lay all parts on a flat surface,
have tools handy and follow these few simple instructions.

2. Set chassis (36) on its wheels and swing support stand (31) to

rear until ends of stand are against stops in chassis end plates.
It is not necessary to loosen nuts (12). See figure 3.

3. Slip reduced ends with holes of side handle tubes (33) into

ends of steering handle tube (30). Line up hole in each end
and insert hook bolt (14) through tubes. Secure with nuts (6).
See figures (1 and 2) for correct position of all parts.
NOTE: Hold hook bolt with pliers when tightening nut with
wrench. Make certain hook bolt points to rear of sweeper.

4. Now, slip bottom ends of side handle tubes (33) inside chassis

(36) See Figure 8. Make certain side tubes hit bottom stop of
formed socket. Insert bolts (28) thru side handle tube (33) and
chassis (36) and tighten nuts (6) securely. See figure 3.

5. Hang hamper (35) inside handle assembly with rear hamper

rod (32) in hooks (14). Place front hamper rod (32) in slots
“Y” of chassis end plates. See figure 2 and 4. Fasten hangers
(5) on side handles. Tilt hanger in—slide and twist out over
tube. See figure 6. Make certain tape “Z” is outside hamper.

All “right” and “left” directions should be considered as from

your position behind the sweeper

CHASSIS (36)
(The correct positioning of the handle tubes as you are looking into

the brush assembly of the chassis)

FIG 8

LEFT SIDE HANDLE RIGHT SIDE HANDLE

TUBE TUBE

ASSEMBLY