MIDMARK CORPORATION Care Exchange Operating Manual

2

then

charge

it.

deploy

it.

April 201

Table of Content

s

S

.

3

8

............................................................

1

..............................................................................

6

:

i

:

g

g

.

B

:

g

.

g

m

ummary of Warnings ....................................................................................

roduct Introduction ........................................................................................

Charging Unit ..................................................................................................

ower System Overview ..............................................................................-

ower System Removal/Installation

asic Troubleshooting

9-1

12-1

Software Note

Midmark requires the installation and utilization of the TrippLite Software for
warranty covera
and will aid in troubleshootin

e. This software provides powerful monitoring performance

the system

Software Pre-Installation Note

Before installing the Tripplite Software (PowerAlert Local or PowerAlert Network
Management System), you must install Java Runtime Environment. The latest

on and installation instructions are available at www.java.com

vers

Software Installation Note

To download the latest software go to http://www.tripplite.com/en/products/

poweralert-software.cfm. Downloadin

the PowerAlert installer guarantees that

ou have the newest available version of PowerAlert

Most applications will need the PowerAlert Local Software. If you will be
trackin

multiple carts from one location, you will need the PowerAlert

etwork Management Syste

Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com | AS-915 Rev.

Summary of Warnings

A

.

ill

n

S.

.

use excessive force to make connections

.

.

g

.

y

g

p

ounted to

ead Acid

d

hPA; Humidi

g.

l

800

K

lease read all parts of this guide. When set-up is complete, do not discard guide.
lease fi le guide in secure place for future reference.

ppropriate airfl ow is required for this unit to operate correctly under normal and fault conditions.

Complies with requirements for US for outside the patient environment.

Only authorized personnel, experienced in servicing electrical equipment should open the power system.

DO NOT operate the power system without the covers completely installed and the connectors attached properly. The covers
provide safety from potentially dangerous voltages

Do not connect or disconnect the system while power is applied. Do not open or in any other manner change the access to the
internal portion of the system while power is applied.

Do not allow the system to come in contact with fl uids. Do not operate the system if wet.

The supplied spiral cord is rated for medical use. Connecting the cord to an outlet that is not medical grade (indicated with

reen dot) w

ipral cord, power system and cart are for INDOOR use only. DO NOT OPERATE OUTDOOR

Inspect spiral cord before each use. DO NOT USE CORD IF DAMAGED.

not ensure grounding protectio

DO NOT plug more than the specifi ed number of watts into spiral card cord.

DO NOT run spiral cord through doorways or across walls or fl oors

Fully insert spiral cord plug into outlet. DO NOT unplug by pulling on cord

DO NOT remove, bend or modify any metal prongs or pins of spiral card cord.

DO NOT

.

Keep spiral cord away from water. DO NOT PLUG CORD INTO OUTLET IF WET

Keep children away from spiral cord

DO NOT ALLOW CORD TO OVERHEAT

DO NOT drive, drag or place objects over spiral cord. Do not stand or walk on spiral cord.

Breakin

the seal on the battery to add water will damage the battery and could cause injury

Battery warranty is automatically void when a fully discharged battery is left in an unused state formore than three (3)
consecutive da

The power system is desi
on the cart into the
m

s.

ower system outlets. DO NOT connect cart mounted equipment directly into a power source that is not

the cart.

led L
Battery must be
recycle

ned for power cart mounted equipment only. DO NOT connect equipment that is not mounted

tore this system within a

temperature range of 32˚ F - 90˚ F

0˚ C - 32˚ C); Pressure 500 hPa to

060

95% RH non-condensin

ty 20% RH to

Transportation/Storage

Cart Disposal

To dispose of this cart using the local
guidelines and regulations for waste.
Please contact Midmark Technica
Service Department for information:

1.

.MIDMAR

3 Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com | AS-915 Rev.B

Product Introductio

n

n

g

r

)

g

t

M

m

C

6

8

7

17

5

4

3

1

13

9

2

Standard Features:

1. Height Adjustment Colum

2. Highly Mobile 100mm Heavy Duty Casters

3. Swivel-out (Swing A Mouse) Mousin

4. Height Adjustment Hand Leve

5. Front Handle with Remote User Interface (RUI

6. Thermofoil (3D Laminate) Worksurface with
Inte

7. Upper Worksurface with Integrated Keyed
Security Syste

8. Flat Screen Monitor Ar

rated Black Vinyl Palm Suppor

16

17

11

10

15

. Power System & Battery Compartment

0. Internal Cord Tray

1. Cord Tray Cover (Clear Acrylic)

2. 3-Outlet Power Cord

3. Coiled Power Cord

4. Coild Power Cord Plug Holder

5. Battery Access Panel (front)

6. Power System Access Panel (back)

7. Cable Management

8. Rear Basket (Optional)

12

14

18

Midmark

orporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com | AS-915 Rev.B

g

g

y

.

.

t

f

.

S

f

.

harging Your Cart

Once cart is fully set up with all electronic devices, it should be plugged into a medical grade outlet.

The cart should fully char

in warehouse before deploying, charge fully).

While the cart is charging, the LED on the power system

e before deploying (Note: All carts are shipped with a 30% charge. If storin

external user interface will fl ash until the batter

For LiFe Batteries: Allow up to 2 hours to fully charge

For SLA Batteries: Allow up to 5 hours to fully charge.

is 100% full

Testing Your Car

To test your cart for power, the unit needs to be turned on. To do so,

ress and hold the power button on the power system user interface for approximately 2 seconds.

The power system will beep and the

connected to the outlet strip should receive power

Note: Monitors, laptops and other devices will need to be manually turned on.

ar left LED light will turn on. At this point, all powered devices

oftware Pre-Installation/Installation Note:

Please refer to the Power Alert

oftware Quick Start Guide and Tripplite User’s Guide

or proper Pre-installation and Installation of the software

5 Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com | AS-915 Rev.B