Midland Radio Corporation AVP4, AVP6 Owner's Manual

AVP4, AVP6 Owner’s Guide

Installing the Battery Packs:

1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the battery
compartment cover by pressing down on the top center and
sliding it down from the radio.

2. Insert the Midland NiMH battery pack into battery compartment.

3. Replace the battery cover by sliding it up on the radio. Replace
the belt clip, making sure it locks into place.

Charging the Battery Packs:

1. Place the rechargeable battery packs into the radios, making sure to
match up the battery contacts in the radios.

2. Connect the AC adapter into an AC wall outlet.

3. Insert the AC adapter plug (or optional DC Cigarette Lighter adapter if
charging in vehicle) into the desktop charger jack.

4. Place the radios into the desktop charger slots and note that the LED
indicator will light up, indicating charging function.

 Only use the Midland NiMH battery pack.
 Do not attempt to charge alkaline batteries or any batteries or

battery packs other than the one indicated in the manual. This
may cause leakage and damage to the radio.

 For long-term storage of the radio, turn the radio OFF and

remove the batteries from the radio

Initial charge time is 24 hours with a charge time of 8-12 hours
thereafter. For maximum battery life, we recommend charging the battery
pack when the low battery icon displays on your radio. Remove the
radios from the charger when the charge time expires.

Midland Radio Corporation

5900 Parretta Drive

Kansas City, MO 64120
www.midlandradio.com