Midland T10, T30 Instruction Manual

Model T10 & T30 Series

Page 1

midlandusa.com

Welcome to the world of Midland electronics

Congratulations on the purchase of your high quality MIDLAND
product. Your two-way radio represents state-of-the-art high-tech
engineering and is designed for GMRS (General Mobile Radio
Service) operation. It is a quality piece of electronic equipment,
skillfully constructed with the finest components. The circuitry is all
solid-state and mounted on a rugged printed circuit board. Your two­way radio is designed for reliable and trouble-free performance for

years to come.

Features

- 22 GMRS/FRS Channels

- 38 Privacy Codes (CTCSS)

- VOX

- Call Alert

- NOAA Weather Radio

- NOAA Weather Alert

- Scan Function

- Monitor Function

- Roger Beep Tone

- Silent Operation

- Key Pad Lock

- Speaker / Microphone Jacks (T31 only)

- Battery Meter / Battery Low Indicator

- USB Jack Charging (T31 only)

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device does not cause harmful
interference, and (2) this radio must accept any interference that may
cause undesired operation.

To maintain compliance with FCC’s RF exposure guidelines, for body-worn
operation, this radio has been tested and meets the FCC RF exposure
guidelines when used with Midland Radio Corp. accessories supplied or
designated for this product. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.

Model T10 & T30 Series

Page 2

midlandusa.com

IMPORTANT NOTICE, FCC LICENSE REQUIRED FOR GMRS OPERATION
(Only Applicable for GMRS Radio Use in the United States)

The radios operate on GMRS (General Mobile Radio Service) frequencies which
require an FCC (Federal Communications Commission) license. You must be
licensed prior to operating on channels 1 - 7 or 15 - 22, which comprise the
GMRS channels of the radios. Serious penalties could result from unlicensed
use of GMRS channels, in violation of FCC rules, as stipulated in the
Communications Acts Sections 501 and 502 (amended).

You will be issued a call sign by the FCC which should be used for station
identification when operating the radio on GMRS channels. You should also
cooperate by engaging in permissible transmissions only, avoiding channel
interference with other GMRS users, and being prudent with the length of your
transmission time.

To obtain a license or ask questions about the license application, contact the
FCC at 1-888-CALL FCC or go to the FCC's website:

http://www.fcc.gov

and request form 605.

Exposure To Radio Frequency Energy

Your Midland radio is designed to comply with the following national and
international standards and guidelines regarding exposure of human beings to
radio frequency electromagnetic energy:

- United States Federal Communications Commission, Code of Federal
Regulations: 47 CFR part 2 sub-part J

- American National Standards Institute (ANSI)/Institute of Electrical &
Electronic Engineers (IEEE) C95. 1-1992

- Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1999 Edition

- National Council on Radiation Protection and Measurements (NCRP) of the
United States, Report 86, 1986

- International Commission on Non-lonizing Radiation Protection (ICNIRP)
1998

To control your exposure and ensure compliance with the general population or
uncontrolled environment exposure limits, transmit no more than 50% of the
time. The radio generates measurable RF energy exposure only when
transmitting.

IMPORTANT: Changes or modifications to this unit not expressly
approved by MIDLAND RADIO CORP. could void your right to operate
this unit. Your radio is set up to transmit a regulated signal on an assigned
frequency. It is against the law to alter or adjust the settings inside the
COMMUNICATOR to exceed those limitations. Any adjustment to your
radio must be made by qualified technicians.

Model T10 & T30 Series

Page 3

midlandusa.com

IMPORTANT: This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause
undesired operation of the device.

IMPORTANT: Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi même si le
brouillage est susceptible d'en compromettre le fonctionnement.

Model T10 & T30 Series

Page 4

midlandusa.com

LCD DISPLAY

1. NOAA WEATHER (WX) BAND ICON –

Indicates when the radio is in Weather
Band mode.

2. KEY LOCK ICON – Indicates KEY
LOCK mode is on.

3. VOX ICON – Indicates when VOX mode
is active.

4. CHANNEL NUMBER – Changes from
1~22 on GMRS/FRS band (1~10 on WX
band).

5. PRIVACY CODE – Indicates Privacy
Code selected by user (oF~38).

6. BATTERY METER – Indicates the battery
level.

7. RECEIVE (RX) ICON – Indicates radio is
receiving a transmission

.

8. TRANSMIT (TX) ICON – Indicates radio
is transmitting a signal.

9. PRIVACY CODE ICON – Indicates
Privacy Code is on.

1

CONTROLS

10. PTT Button – Press and hold to

transmit voice communication.

11. CALL/LOCK Button – Press to send a

CALL ALERT signal. Press and hold to
turn KEY LOCK on/off.

12. MIC – Built-in microphone.

13. USB CHARGING JACK (T31 only)

14. SPEAKER – Built-in speaker.

15. ANTENNA

16. EXTERNAL SPEAKER/MIC JACK

(T31 only)

17. MENU Button – Press momentarily to

access Menu mode.

18. MONITOR/SCAN Button – Press to

enter SCAN mode. Press and hold to
enter MONITOR mode.

19. UP/WX



and DOWN



Buttons –

Make adjustments in MENU mode.
Press and hold the UP button for 3
seconds to activate the NOAA Weather
Radio function.

16

15

14

12

11

10

7

6

3

2

13

17

4

5

8

9

18

19

Model T10 & T30 Series

Page 5

midlandusa.com

BATTERY INSTALLATION

Your radio operates with either 3 AAA NiMH batteries or optional 3
AAA alkaline batteries. The belt clip should be removed (see below)
to ease installation or removal of the batteries.
To install the batteries:

1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover by
pressing down on the top center and sliding it down from the radio.

2. Insert 3 AAA NiMH batteries or 3 AAA batteries observing the
polarity as shown. Installing the batteries incorrectly will prevent
the unit from operating or may damage the unit.

3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.

BATTERY
COMPARTMENT

BATTERY
COMPARTMENT
COVER

Press here and
push down to open

BELT CLIP
LOCK TAB

BELT CLIP
LATCH

INSTALLING THE BELT CLIP

To install the BELT CLIP, slide the clip down into the slot on the back
of the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP, pull the LOCK TAB away from the radio, then gently pull the
belt clip up toward the top of the radio.