MIDEA BLANC RG70A/BGEF, RG70E/BGEF User Manual
CR170-RG70A
16117000000634
U
SER MANUAL
MIDEA BLANC
Thank you very much for purchasing our air conditioner.
Please read this owner's manual carefully before using
your air conditioner.
The design and specifications are subject to change without prior notice
for product improvement. Consult with the sales agency or manufacturer
for details.
11
CONTENTS
22
Model
Rated Voltage
8m
3.0V(Dry batteries R03/LR03 2)
RG70A/BGEF, RG70E/BGEF
Remote Controller Specifications
Environment
Signal Receiving Range
-5 C 60C
~~
1
2
4
5
3
9
10
11
12
13
8
6
7
1
2
3
4
ON/OFF Button( )
This button turns the air conditioner ON
and OFF.
Operation of buttons
Temp Up Button( )
Push this button to decrease the set
temperature or Timer setting hours.
Temp Down Button( )
Press this button to increase the set
temperature or Timer setting hours.
NOTE
When the air conditioner operates under
heating mode with the set temperature of
O
17 C, pressing button continously for
two times will activate 8 Degree heating.
The indoor unit display shows FP .
,,
,,
Sleep button(applicable to RG70A/BGEF)
Used to active/cancel Sleep mode. It can
maintain the most comfortable temperature
and save energy. This function is available
on COOL, HEAT or AUTO mode only .
For the detail, see sleep operation in
USER S MANUAL.
,
,,
,,
,,
,,
Temp
Mode Fan
OK
Timer
Sleep
Super Fav.
Options
Press this button to modify the air conditioner
mode in a sequence of following:
Mode Button
AUTO
COOL
DRY
HEAT
FAN
NOTE Please do not select HEAT mode if the
machine you purchased is cooling only type.
Heat mode is not supported by the cooling only
appliance.
RG70A/BGEF
Used to enter the energy efficient mode.
Under cooling mode, press this button, the
remote controller will adjust the temperature
O
automatically to 24 C, fan speed of Auto to
save energy(but only if the set temperature
O
is less than 24 C). If the set temperature is
OO
between 24 C and 30 C, press the ECO
button, the fan speed will change to Auto,
the set temperature will remain unchanged.
ECO Button(applicable to RG70E/BGEF)
1
2
6
7
7
8
9
9
13
Handling the remote controller ......................................................
Remote controller Specifications...................................................
Operation of buttons ............ .........................................................
Indicators on LCD ..........................................................................
How to use the buttons .................................................................
AUTO/COOL operation....................................................................
DRY/FAN operation.........................................................................
HEAT operation ..............................................................................
Setting the Timer function .............................................................
33
44
1
2
4
5
3
9
10
11
12
13
8
6
7
5
6
7
8
Operation of buttons
Temp
Mode Fan
OK
Timer
ECO
Super
Gear
Options
Timer Button
Super Button
Press this button to initiate the auto-on/
auto-off time sequence.
Press this button under cooling operation,
O
the set temperature will change to 17 C,
the fan speed shift to high and bring faster
cooling operation.
Press this button under heating operation,
O
the set temperature will change to 30 C,
the fan speed shift to high and bring faster
heating operation.
NOTE:
This function is not available under AUTO,
DRY,FAN,Self Clean or Comfort mode.
Press MODE,FAN,SLEEP or ECO button
will cancel Super function.
RG70E/BGEF
NOTE:
Pressing the SLEEP button, or modifying the
mode or adjusting the set temperature to
O
less than 24 C will stop ECO operation.
Under ECO operation, the set temperature
O
should be 24 C or more. it may result in
insufficient cooling. If you feel uncomfortable,
just press the ECO button again to stop it.
Do Not Disturb Button( )
Used to select the fan speed in four steps:
AUTO LOW MED HIGH
Fan Button
You can not switch the fan speed in AUTO
or DRY mode.
Press Fan, MODE, Sleep, ON/OFF ,ECO or
Gear button will cancel the Silent function.
NOTE
Hold down this button for at least 2 seconds
to activate/cancel Silent mode. Due to low
frequency operation of compressor, it may result
in insufficient cooling and heating capacity.
Operation of buttons
9
10
11
1
2
4
5
3
9
10
11
12
13
8
6
7
Temp
Mode Fan
OK
Timer
Sleep
Super
Fav.
Options
RG70A/BGEF
Swing Button
OK Button
Swing Button
Used to confirm the optional fucntions.
Used to stop or start horizontal louver movement or set the desired up/down air flow
direction. The louver changes 6 degree in
angle for each press. If keep pushing more
than 2 seconds, the louver will swing up and
down automatically.
Used to stop or start vertical louver movement
and set the desired left/right air flow direction.
The louver changes 6 degree in angle for each
press. If keep pushing more than 2 seconds,
the louver will swing up and down automatically.
Options Button
12
Press this button to select the air conditioner
function in a sequence of following:
Self clean
Follow me
Fresh
Press the Options button to select the desired
function, the selected symbol will flash on
the display area, then press the OK button
to confirm.
Comfort
FRESH function( )
When the FRESH function is initiated, the
Ionizer/Plasma Dust Collector(depending on
models) is energized and will help to
remove pollen and impurities from the air.
FOLLOW ME function( )
Comfort function( )
When the Follow Me function is activated,
the remote display is actual temperature
at its location. The remote control will send
this signal to the air conditioner every 3
minutes interval until press the FOLLOW
ME button again.
When the Comfort function is activated,
O
the air conditioner will be set at 23 C
automatically. It is not available under
fan mode.
Press this button to turn off the indoor screen
display, and also turn off the Air conditioner
buzzer, the fan speed shifts to low, which
create a comfortable and quiet environment.
Press it again to cancel this function.
Under Do Not Disturb mode, the display
will illuminate for 10 seconds while adjusting
the mode, set temperature or fan speed, etc.
Loading...