Midea MWD-40P User manual

Floor Washer

PLEASE READ THE
MANUAL CAREFULLY
BEFORE USING AND
KEEP IT PROPERLY
FOR FUTURE USE

INSTRUCTION MANUAL

Warning notices: Before
using this product, please
read this manual carefullly
and keep it for future
reference.
The design and
specifications are subject to
change without prior notice
for product improvement.
Consult with your dealer or
manufacturer for details.

MWD-40P

Safety Instructions

This product is suitable for hard floors in the indoor home environment, including waxed,

stone, rubber, marble, granite, terrazzo, solid wood, laminate, bamboo floors and various
mirror tiles, porcelain tiles and other flat surfaces. The product may not reach the best
performance on uneven surfaces.

Do not use this product near or on surfaces that are flammable or explosive, which may

lead to a risk of fire and explosion.

Do not use this product near a working fireplace or heater to prevent deformation of

the casing.

Do not suck in hot substances (unextinguished cigarettes, matches or hot ashes, etc.),

ultra-fine substances (such as lime, cement, wood chips, gypsum powder, ashes,
charcoal powder, etc.), hazardous substances (such as solvents, descaling agents, etc.),
chemical substances (such as acids, cleaning agents, etc.), and other substances with
uncertain physical properties.

Do not use this floor washer to suck up detergent, kerosene, gasoline, alcohol, paint,

perfume, etc. These liquids may cause a short circuit, fire or explosion in the machine.

Do not use this floor washer to suck toners used in laser printers and copiers, which may

cause fire or explosion.

Do not use this floor washer to suck up sharp or large objects such as glass fragments,

small toys, pins, paper clips, stones, plaster, large pieces of paper, which may jam and
damage the machine.

Do not use the floor washer to suck up any burning or smoking objects, such as ashes

from unextinguished heat sources, burning cigarette ends or matches, etc. Stains such
as shoe polish, paint and pigments that are strongly greasy, sticky or stained shall not be
cleaned using this device.

Do not touch the plug or any live part of the product with wet hands to avoid electric

shock.

If the plug is damaged, do not use it any longer. Please call our professional maintenance

personnel to replace the damaged plug to prevent hazards.

Keep the airflow channels and moving parts of this product away from long hair, loose

clothing, fingers and other body parts. Do not point the vacuum hose, attachment wand
or tool at your eyes, ears, or put them in your mouth.

Please use the cleaners made by our company and our approved manufacturers, and do

not add other solutions to avoid toxic and harmful gases.

When using the device, in case of current leakage or over temperature or noise of the

motor, as well as other abnormal conditions such as body overheating, noise, odor or
weak suction, you should immediately stop using the device and call our professional
maintenance personnel.

After using the device, please clean up the sewage bucket in time to avoid odor and keep

the ventilation path open to avoid blockage causing a decrease in suction power and
motor heating, thus affecting the service life of the floor washer.

After using the machine, please keep it in a dry place. Humidity will affect the insulation

and service life of the machine. The floor washer body and floor brush have energized
settings and cannot be soaked or rinsed in water.

Please check the condition of the nozzle regularly. If there is any blockage, please clear it

in time to avoid the decrease of suction power caused by the blockage, affecting the

performance of the machine.
Make sure to turn off the machine before replacing the rolling brush.
In case of any of the following conditions, please don't use the machine and send it to the

service store assigned by our company:

1. The cleaner has fallen from a high place, leading to obvious damage or operation
failure.

2. The power cord is damaged.

Do not disassemble the closed machine by yourself. There are no parts in this machine

that can be repaired by customers themselves. Do not try to modify the performance of
the machine, otherwise it will lead to danger.

The use of voltage that does not meet the specifications of the product will damage the

product and may cause injury to the user.
When sweeping stairs, extra care should be taken to prevent falling.
Do not shake the machine up and down or bump it violently to prevent sewage from

flowing into the motor.
When the motor is working, do not lift or carry the machine up and down, and do not put

the machine to one side or flat to prevent sewage from flowing back to the motor.
To prevent tripping and falling, the machine should be placed against the wall after using it.
Do not use the machine if the fresh water tank and sewage tank are not properly installed.
Do not place any small objects on the air outlet, do not block the air outlet, and remove

any small objects that may hinder the smooth airflow of the air outlet to prevent the

machine from overheating.
Do not get the machine body wet, otherwise there is a risk of fire due to short circuit of

the machine.
All technical and other data contained in the Use Instructions is obtained by our company

or a designated third party testing company. The final interpretation right belongs to our

company

Safety Instructions

After using the device, please clean up the sewage bucket in time to avoid odor and keep

the ventilation path open to avoid blockage causing a decrease in suction power and

motor heating, thus affecting the service life of the floor washer.
After using the machine, please keep it in a dry place. Humidity will affect the insulation

and service life of the machine. The floor washer body and floor brush have energized

settings and cannot be soaked or rinsed in water.
Please check the condition of the nozzle regularly. If there is any blockage, please clear it

in time to avoid the decrease of suction power caused by the blockage, affecting the

performance of the machine.
Make sure to turn off the machine before replacing the rolling brush.
In case of any of the following conditions, please don't use the machine and send it to the

service store assigned by our company:

1. The cleaner has fallen from a high place, leading to obvious damage or operation
failure.

2. The power cord is damaged.

Do not disassemble the closed machine by yourself. There are no parts in this machine

that can be repaired by customers themselves. Do not try to modify the performance of
the machine, otherwise it will lead to danger.

The use of voltage that does not meet the specifications of the product will damage the

product and may cause injury to the user.
When sweeping stairs, extra care should be taken to prevent falling.
Do not shake the machine up and down or bump it violently to prevent sewage from

flowing into the motor.
When the motor is working, do not lift or carry the machine up and down, and do not put

the machine to one side or flat to prevent sewage from flowing back to the motor.
To prevent tripping and falling, the machine should be placed against the wall after using it.
Do not use the machine if the fresh water tank and sewage tank are not properly installed.
Do not place any small objects on the air outlet, do not block the air outlet, and remove

any small objects that may hinder the smooth airflow of the air outlet to prevent the

machine from overheating.
Do not get the machine body wet, otherwise there is a risk of fire due to short circuit of

the machine.
All technical and other data contained in the Use Instructions is obtained by our company

or a designated third party testing company. The final interpretation right belongs to our

company

Product Introduction

Introduction to Parts

Mode switching
button

Fresh water tank

Sewage release
button

Sewage tank

Ground brush

Switch button

Display

Upper cover of
fresh water tank

Handle of
sewage tank

Handle

Voice switch button

Ground brush cover

List of accessories

Hepa

Cleaning brush Cleaning spoon

Accessory holderAdapterCharging base Cleaning fluid

Manual

Use Instructions

Rolling brush

Product Introduction

Accessories Introduction

Cleaning brush

1

A brush at one end, which can be used to

clean the stubborn dirt attached to the
inner wall of the sewage tank.

The other end is a rotating blade that can

be used to clean the tangled hairs on the
rolling brush.

Accessory holder

3

It can be used to store rolling brush,

cleaning brush and Hepa;

Insert the projection part of the accessory

holder into the slot of the charging base to
fix it (there are slots on both sides of the
charging base for fixing accessory holder)

Cleaning spoon

2

The cleaning spoon has a folding

extension handle, which can be unfolded
for use when needed according to the
illustration;

It can be used to filter solid waste such as

particulate matters and hair.

Cleaning liquid

4

To carry out depth cleaning, just put

cleaning liquid into the water tank after it is
filled with water according to the specified
proportion.

Slot (on both sides)