Part 1 General Information ........................................................................2
Part 2 Outdoor units...................................................................................7
Part 3 Installation......................................................................................63
Part 4 Controller .......................................................................................79
Contents i
MCAC-TSM-2008-02 Introduction
Introduction
Midea Mini Unitary Chiller is air-cooled chiller and heat pump system, the chiller itself built in with water
pump, expansion tank, plate heat-exchanger; it is very simple for installer to install such kind of system.
Expansion Tank
Pressure
Difference Switch
Plate Heat-exchanger
Water Pump
Introduction 1
General Information MCAC-TSM-2008-02
Part 1
General Information
1. Model Names of Outdoor Units....................................3
Outdoor air flow m3/h 5563 5624
Throttle Capillary Capillary
Outdoor noise level (sound pressure) dB(A) 55 56
Water flow volume m3/h 0.86 1.24
The plate heat-exchanger water pressure drop kpa 21 35
The Max. and Min. water inlet pressure kpa
Dimension (W×H×D) mm 990×966×354 990×966×354
Outdoor unit
Refrigerant
type/Quantity
Connection
wiring
Pipe diameter Water inlet/outlet mm R1 R1
Control Wired controller Wired controller
Ambient temp. ℃
Nominal capacity is based on the following conditions:
1. Condenser air in 35℃. Evaporator water in/out 12/7℃
2. Evaporator air in 7℃ 85% R.H., Condenser water in/out 40/45℃
3. The two types of oil are equivalents
4. At 1m in open field fan side (sound pressure)
5. The maximum and minimum operating pressure values refer to the activation of the pressure switches
Packing (W×H×D) mm 1120×1100×435 1120×1100×435
Net/ Gross weight kg 83/89 94/100
Type R410A R410A
Charged volume g 1600 2100
Power wiring mm2 3×2.5 3×2.5
Signal wiring (connect to wired
control)
mm
2
500/150 500/150
3×1.0 3×1.0
Cooling: 10℃~43℃; Heating: -15-24℃
8 Installation
MCAC-TSM-2008-02 Outdoor units
Si
Model MGC-F09W/N1 MGC-F10W/N1
Power supply V-Ph-Hz
Cooling
Heating
Max. input consumption W 4950
Max. input current A 23.1
Starting current A 98
Compressor
Outdoor fan motor
Outdoor coil
Water pump
Capacity kW 9.0
Input W 3540
Capacity kW 9.5
Input W 3820
Model
Type
Brand
Capacity Btu/h
Input W
Rated current (RLA) A
Locked rotor Amp (LRA) A
Thermal protector
Capacitor uF
Refrigerant oil ml
Model
Type
Brand
Input (Hi/Lo) W
Capacitor uF
Speed (Hi/Lo) r/min
Number of rows
Tube pitch(a)× row pitch(b) mm
Fin spacing mm
Fin type
Tube outside dia. and type mm
Coil length ×height × width mm
Number of circuits
Type
Input (H/M/L) W
Outdoor air flow m3/h 6450/4250
Throttle
Outdoor noise level (sound pressure) dB(A) 58/49 60/50
Water flow volume m3/h 1.54
The plate heat-exchanger water pressure drop kpa 42
The Max. and Min. water inlet pressure kpa
Dimension (W×H×D) mm
Outdoor unit
Refrigerant
type/Quantity
Connection wiring
Pipe diameter Water inlet/outlet mm
Control
Ambient temp. ℃
Nominal capacity is based on the following conditions:
1. Condenser air in 35℃. Evaporator water in/out 12/7℃
2. Evaporator air in 7℃ 85% R.H., Condenser water in/out 40/45℃
3. The two types of oil are equivalents
4. At 1m in open field fan side (sound pressure)
5. The maximum and minimum operating pressure values refer to the activation of the pressure switches
Packing (W×H×D) mm 1058×1380×438
Net/ Gross weight kg
Type R410A
Charged volume g
Power wiring mm2 3×4.0
gnal wiring (connect to wired
mm2
Capillary Capillary
500/150 500/150
940×1245×360 940×1245×360
138/145 138/145
3000 3000
3×1.0 3 ×1.0
R5/4 R5/4
Wired controller Wired controller
Cooling: 10℃~43℃; Heating: -15-24℃
6500/4300
1.74
44
1058×1380×438
R410A
3×4.0
Outdoor units 9
Specification MCAC-TSM-2008-02
Model MGC-F10W/SN1 MGC-F12W/SN1
Power supply V-Ph-Hz
Cooling
Heating
Max. input consumption W
Max. input current A
Starting current A
Compressor
Outdoor fan
motor
Outdoor coil
Water pump
Capacity kW
Input W
Capacity kW
Input W
Model
Type
Brand
Capacity Btu/h
Input W
Rated current (RLA) A
Locked rotor Amp (LRA) A
Thermal protector
Capacitor uF
Refrigerant oil ml
Model
Type
Brand
Input (Hi/Lo) W
Capacitor uF
Speed (Hi/Lo) r/min
Number of rows
Tube pitch(a)× row pitch(b) mm
Fin spacing mm
Fin type
Tube outside dia. and type mm
Coil length ×height × width mm
Number of circuits
Type
Input (H/M/L) W
Outdoor air flow m3/h
Throttle
Outdoor noise level (sound pressure) dB(A)
Water flow volume m3/h
The plate heat-exchanger water pressure drop kpa
The Max. and Min. water inlet pressure kpa
Dimension (W×H×D) mm
Outdoor unit
Refrigerant
type/Quantity
Connection
wiring
Pipe diameter Water inlet/outlet mm
Control
Ambient temp. ℃
Nominal capacity is based on the following conditions:
1. Condenser air in 35℃. Evaporator water in/out 12/7℃
2. Evaporator air in 7℃ 85% R.H., Condenser water in/out 40/45℃
3. The two types of oil are equivalents
4. At 1m in open field fan side (sound pressure)
5. The maximum and minimum operating pressure values refer to the activation of the pressure switches
Packing (W×H×D) mm 1058×1380×438 1188×1385×498
Net/ Gross weight kg 131/139 137/145
Type R410A R410A
Charged volume g 2700
Power wiring mm2
Signal wiring (connect to wired
control)
mm2
6465/4270 6470/4280
Capillary Capillary
58/48 59/49
1.72 2.0
44 40
500/150 500/150
940×1245×360 1070×1249×420
5×2.5 5×2.5
3×1.0 3×1.0
R5/4 R5/4
Wired controller Wired controller
Cooling: 10℃~43℃; Heating: -15-24℃
3000
10 Installation
MCAC-TSM-2008-02 Outdoor units
Model MGC-F14W/SN1 MGC-F16W/SN1
Power supply V-Ph-Hz
Cooling
Heating
Max. input consumption W
Max. input current A
Starting current A
Compressor
Outdoor fan motor
Outdoor coil
Water pump
Capacity kW
Input W
Capacity kW
Input W
Model
Type
Brand
Capacity Btu/h
Input W
Rated current (RLA) A
Locked rotor Amp (LRA) A
Thermal protector
Capacitor uF
Refrigerant oil ml
Model
Type
Brand
Input (Hi/Lo) W
Capacitor uF
Speed (Hi/Lo) r/min
Number of rows
Tube pitch(a)× row pitch(b) mm
Fin spacing mm
Fin type
Tube outside dia. and type mm
Coil length ×height × width mm
Number of circuits
Type
Input (H/M/L) W
Outdoor air flow m3/h
Throttle
Outdoor noise level (sound pressure) dB(A) 60/50
Water flow volume m3/h
The plate heat-exchanger water pressure drop kpa
The Max. and Min. water inlet pressure kpa
Dimension (W×H×D) mm
Outdoor unit
Refrigerant
type/Quantity
Connection wiring
Pipe diameter Water inlet/outlet mm
Control
Ambient temp. ℃
Nominal capacity is based on the following conditions:
1. Condenser air in 35℃. Evaporator water in/out 12/7℃
2. Evaporator air in 7℃ 85% R.H., Condenser water in/out 40/45℃
3. The two types of oil are equivalents
4. At 1m in open field fan side (sound pressure)
5. The maximum and minimum operating pressure values refer to the activation of the pressure switches
Packing (W×H×D) mm
Net/ Gross weight kg 145/160
Type
Charged volume g
Power wiring mm2