Midea FZ.411.SS User Manual

CONGRATULATIONS

FZ.411.SS

Dear Customer,

Thank you for purchasing our Vogue Refrigerator. We are sure you will nd your new appliance a
pleasure to use. Before you use the appliance, we recommend that you read through this entire user
manual, which provides the description of the appliance and its functions.

To avoid the risks that are always present when you use an electrical appliance, it is important that
the appliance is installed correctly and that you read the safety instructions carefully to avoid misuse
and hazards.

We recommend that you keep this instruction booklet for future reference and pass it on to any future
owners. After unpacking the appliance, please check that it is not damaged. If in doubt, do not use the
appliance but contact your local customer care centre.

AFTER POSITIONING THE REFRIGERATOR DO NOT PLUG IN FOR A MINIMUM OF

6 HOURS TO ALLOW THE GAS TO SETTLE

1. IMPORTANT – CHECK FOR ANY DAMAGES OR MARKS

If you nd the refrigerator is damaged or marked, you must report it within 7 days if you wish to claim
for damage/marks under the manufacturer’s warranty. This does not affect your statutory rights.

2. CORRECT USE OF YOUR APPLIANCE

• Remove all packaging material before using the refrigerator. This includes the foam base and

all adhesive tape holding the accessories inside and outside.

• Clean the inside and outside of the refrigerator with a wet cloth (a little detergent can be added
to the water) and then wipe again with a clean cloth.

• The appliance needs to have an independent power socket.

• Screw on bottom cover

Page 1 of 16

3. TRANSPORTING

• When moving do not tilt over more than 45 degrees.

4. WARNING

• Keep ventilation openings in the appliance or in the built-in-structure clear of obstruction.

• Do not use mechanical devices or other means to accelerate the defrosting process.

• Do not damage the refrigerant circuit.

• Do not use electrical appliances inside the appliance.

• The appliance needs to be unplugged before carrying out any maintenance.

• If the electrical cord is damaged it must be replaced by a service agent or similarly qualied
person.

• Please handle and dispose of the appliance according to local regulations as it uses

ammable gas and refrigerant.

• Do not store explosive substances such as aerosol cans with ammable propellants in this
appliance.

5. LOCATION

Ensure adequate air circulation around your appliance; do not place the unit near any heat source,
direct sunlight, moisture or water to avoid rust and damaging the insulation.

Space at top of unit should be at least 30cm, sides and back at least 10cm from wall to allow doors to
open and close easily.

Install the appliance on a solid level oor. (If not level adjust the leveler)

Do not allow the power cable to be compressed by the refrigerator or heavy object which could dam-

age it causing power surges.

Before connecting to the power check the voltage and power supply carefully.

Page 2 of 16

Upright Freezer

User’s Manual

Model: FZ.411.SS

Page 3 of 16

This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.

WARNING:

-WARNING: Keep ventilation openings

, in the appliance enclosure or in the built-in

structure, clear of obstruction.

-WARNING: Do not use mechanical devices or other means to accelerate the

defrosting process, other than those recommended by the manufacturer.

-WARNING: Do not damage the refrigerant circuit.

-WARNING: Do not use electrical appliances inside the food storage compartments

of the appliance, unless they are of the type recommended by the manufacturer.

-Do not store explosive substances such as aerosol cans with a flammable propellant

in this appliance.

This appliance is inten

ded to be used in household and similar applications such as
staff kitchen areas in shops, offices and other working environments;
farm houses and by clients in hotels, motels and other residential type environments;
bed and breakfast type environments;
catering and similar non-retail applications.

Energy Saving Tips

· The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.

· Let hot foods cool to room temperature before placing in the appliance.
Overloading the app

liance forces the compressor to run longer. Foods that freeze too

slowly may lose quality, or spoil.

· Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.

· Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less
efficient.

· Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.

Page 4 of 16

PROPER USE OF REFRIGERATOR

The coming of new fridge

l Before the use of the fridge, remove all packages, including bottom cushion and foam pads
and rubber belts in the fridge;
l Clear the outside and inside of the fridge with a piece of warm wet rag (little detergent can
be added into the warm water. Clear the fridge with fresh water at last);
l Prepare a separate two-pole grounding receptacle.
Do not share a multi-socket with other electric appliances.

l The ground wire must be well connected and the grounding pole of the receptacle should be
grounded reliably.
l Open the door, take ou
in the bag of the instruction. And install it onto the bottom beam of the fridge. For operation
method, see the right diagram.

Transport and placement of fridge
Transport

l Do not invert, place horizontally, squeeze or shock the fridge. And the declination angle of
the fridge must be no more than 45

l When moving, do not force too much on the door or top for fear of deformation.

Placement

l Place the fridge at a well-ventilated place and keep it away from heat and direct sunshine.
Never put it at a damp or wat
l The top clearance outside the fridge must be no less than 30cm, and the clearance from both
sides and back to the walls must be no less than 10cm for the convenience of opening and heat
emission.
l Put the fridge on the flat and solid ground. (adjust the adjustable legs to get balance if
unstable).

t the attachments (the bottom decorative cover), and three setscrews

° when moving.

ery place, for fear of rusting or weakening the insulation.

Standing

l Do not switch on the fridge immediately after vertical placement. Only switch it on after 6
hours' standing to ensure its proper operation.

Notice

To prevent damage to the power cord and any consequent incidents, the power cord should
not be covered by the fridge or other objects.
Before switching on the fridge, please check carefully whether the voltage range of the fridge
is the same as that of the power supply.

Page 5 of 16

INSTALL THE DOOR HANDLE

Note: Figures in the user manual are only for reference. The actual product may
differ slightly.
The refrigerator must be disconnected from the source of electrical supply before
attempting the installation of accessory.

③

②

①

the ho le

the sc rew

③

①

②

①take out the two crisscross-screw;and install them into the door holes;

turn the screws till to the bottom;

②aim at screws to install the handle;

③the screws in the hole at the side of the handle and turn the screws till

them very tight.

NOTE:the screws and wrench are in the plastic bag.

Page 6 of 16

PARTS LIST

Note: Figures in the user manual are only for reference. The actual
product may differ slightly.

1. lamp switch 2 lamp cover.
3 temperature sensor gap .
5 outlet airflow gap.

9 steel wire door tray.

4 steel wire freezer shelf.

6. inlet airflow gap
8 door tray. 7 steel wire drawer.

10 lock.

Page 7 of 16

INSTALL THE DECORATIVE COVER FOR BOTTOM BEAM

The coming of new refrigerator

l Open the door, take out the attachments (the bottom decorative cover), and three
setscrews in the bag of the Instruction. And install it onto the bottom beam of the
fridge. For operation method, see the below diagram.

cover plate

The opposite side on the hinge
is kept and fixed to be level.

①

get rid of the cover plate on
the side of the hinge

get rid of the cover plate on the side of
the hinge， and keep the one on the
other side.

get rid of the cover plate on
the side of the hinge

②

The opposite side on the hinge
is kept and fixed to be level.

Install the bottom decorative cover using screw as below pictures.

Decorative cover for bottom beam

Scre ws

Page 8 of 16

SAFETY PRECAUTION

Page 9 of 16

POSITIONING

Install th is a ppliance in an area w he re t he
ambient te mp erature is betwee n 110 ℉(43℃)

and 32 ℉(0℃).If t he t emperature arou nd t he
applianc e is t oo low or high ,cooli ng a bi lity may
be affected

＞10 0m m

＞30 0m m

＞10 0m m

Page 10 of 16

OPERATION CHECK

30 minutes later,open the freezer
compartment door ,feel the cold air,that means
the unit works properly.
After a period of time to set the freezer
temperature at the desired temperature.
(Set the range from -14 ~-22 ( ))℃ ℃ 7℉ ~ -8℉

Page 11 of 16

FOOD STORAGE

back s id e

air ga p

Page 12 of 16

INTRODUCTION OF THE FUNCTIONS

1 2

FE

G

A B C D

1、Alarm lamp

1.Hi-Temp(High temperature alarm)

2.Door Open(Door keep open for 60 seconds alarm )

2、Button

A.Quick Freeze button B.℃or ℉ temperature switch button
C.Alarm Reset button D.Lock/Unlock button

E.Temperature / Quick Freeze time setting ( ) downsetting
F.Temperature / Freeze time setting ( ) upsetting Quick

3、 Funtion

●Refrigerator and Freezer temperature setting

Press button E or F can easily realize the switching function of Refrigerator and
Freezer.the temperature icon G flickering, set the temperature range as follows：

-24℃ →-23℃ → -22℃ …… → -13℃ → -12℃ →2℃… … 6℃→7℃ → 8℃or 8℃ →
7℃→6℃ …… 2℃ → -12℃ →-13℃ …… -22℃→ -23℃→ -24℃

-11℉→ -10 ℉ → -9 ℉ …… 10℉ →36℉ … … 44 ℉ → 45 ℉ → 46 ℉ or 46 ℉ →45 ℉
→44 ℉ …… 36 ℉ → 10℉ … … -9℉→ -10℉→ -11 ℉
Exits the setting state 10 seconds later and takes effect.(when the temperature adjust,
also can press button D to lock and the temperature setting effect).

WAR NING:

Please remove the food fr
Refrigerator and Freezer.
When adjust the temperature, please pay attention to the real adjusted
temperature for avoiding a mistake that the function directly from
Refrigerator to Freezer or from Freezer to Refrigerator while not remove
the food.

om the cabinet before switching the function of

Page 13 of 16

INTRODUCTION OF THE FUNCTIONS

●Quick Freeze Funtion setting

Un-Quick freeze funtion mode :press button A to enter quick freeze mode,the temperature
icon G show“ 24℃”or“ 11℉” ,quick freeze time acquiesce in 6 hours.Press
button A again to exit.

Quick freeze funtion will not work when the cabinet as the Refrigerator

Quick freeze funtion mode :press button A for 3 seconds to enter the state of quick freeze
time setting,quick freeze time icon G flickering; press button E or F to adjust the quick freeze
time, to choose 6 or 48 hours setting .To exit the setting state 10 seconds later and takes effect.
(also can press button D to lock or button A to exit and setting effect).
(If quick freeze time show 6 hours,press button F to choose 48 hours,while quick freeze
time show 48 hours,press button E to choose 6 hours.48 hours NOT be advised to choose)

● ℉ ℃Temperature or mode

Press button B to switch the freezer temperature show; easily to switch
between and mode.℉ ℃

●Alarm cancel

Press button C to cancel buzzing alarm when freezer high temperature alarm.

- -

●Lock/Unlock

Unlock mode:press button D for 3 seconds to lock; after lock all button are inefficacy
except button D.

Lock mode:press button D for 3 seconds to release ;
When setting temperature and quick freeze time,press button D to exit and setting effect.

Fault content

Freezer temperature sensor failure

Freezer defrosting sensor failure.

Communication failure

Ambient temperature sensor failure

Fault code

E2

E5

E6

E7

visible code

YES

YES

YES

YES

Freezer high temperature.

Please contact the after-sales Service Department of the Company or
professionals to deal with the faults,while the fridge still can keep refrigeration..

Page 14 of 16

E9

YES

MAINTENANCE

LEAVING THE UNIT POWER OFF

If the unit will be power off for a long time,
the plug should be pulled out, then clean
the unit thoroughly.Ensure that the door
cannot be fully closed(leave a suitable gap),
and place the unit in a well-ventilated area
to avoid any odour.

Danger

Risk of child entrapment. Before you throw away your old refrigerator or freezer:
1, Take off the doors
2, Leave the shelves in place so that children may not easily climb inside.

Page 15 of 16

TROUBLE SHOOTING

Please contact the after-sales Service Department of the Company or
professionals to deal with the trouble to avoid any risk.
Before calling for the service ,please check the following issues first.

POSSIBLE CAUSEPROBLEM POSSIBLE SOLUTION

1) Does not work.

2) Refrigerator runs
continuously.

●No power to unit.

●Power cord is u nplugged.

● Wrong voltage is being used.

●Temperature set too low.

●Door is not closed.

● Hot food inse rted.

● Door opened too long or too often.

● Close proximity to heat

source or direct sunlight.

●Something t o plug up inlet

or outlet air flow gap

●Check connection of power
cord to power source.

●Plug in unit.

●Use proper voltage.

● Lower tempe rature control.

● Close door securely.

● Be sure food is a t room

temperatu re before i

● Minimize door openings/
duration.

● Do not place unit close to
heat sources or direct
sunlight.

nserting.

Page 16 of 16