Midea RG70C/BGEF, RG70C1/BGEF, RG70F/BGEF User Manual
The de si gn and specific at ions are subject to c hange without pri or notice
for pr od uct improveme nt . Consult with the sa les agency or manuf acturer
for de ta ils.
AIR CONDITIONER
REMOTE CONTROLLER ILLUSTRATION
Than k yo u very much for pur ch asing our air condi tioner.
Plea se r ead this owner' s ma nual carefully be fore using
your a ir c onditioner.
CONTENTS
Remote controller Specifications...................................................
Operation of buttons ............ .........................................................
Indicators on LCD ..........................................................................
How to use the buttons .................................................................
AUTO/COOL operation....................................................................
DRY/FAN operation.........................................................................
HEAT operation ..............................................................................
Setting the Timer function .............................................................
Handling the remote controller ......................................................
Remote Controller Specifications
Model
Rated Voltage
Signal Receiving Range
Environment
RG70C/BGEF, , RG70C1/BGEF RG70F/BGEF
3.0V(Dry batteries R03/LR03×2)
8m
。 。
-5 C 60 C
~
13
Operation of buttons
ON/OFF Button( )
1
This button turns the air conditioner ON
and OFF.
Temp Up Button( )
2
1
2
6
7
7
8
9
9
1
3
4
5
6
7
Temp
Mode Fan
Sleep
OK
Options
Timer
Turbo LED
RG70C/BGEF
RG70C1/BGEF
Fav.
2
8
9
10
11
12
13
Press this button to increase the set
temperature or Timer setting hours.
Temp Down Button( )
Push this button to decrease the set
temperature or Timer setting hours.
NO TE：
When the air conditio ne r op er ates under
heating mode with the s et t em pe rature of
O
17 C, pressing button c on ti no usly for
two times will activa te 8 D eg re e heating.
The indoor unit displ ay s ho ws F P .
Mode Button
3
Press this button to modify the air conditioner
mode in a sequence of following:
AUTO
NO TE：Pl ea se do not s elect H EAT mode i f th e
machi ne y ou purc hased i s co oling o nly typ e.
Heat mo de i s not sup porte d by t he cool ing onl y
appli an ce.
Sleep button(applicable to
4
RG70C(1)/BGEF)
Used to active/cancel Sleep mode. It can
maintain the most comfortable temperature
and save energy. This function is available
on COOL, HEAT or AUTO mode only .
For the detail, see sleep operation in
,,
USER S MANUAL.
ECO Button(applicable to RG70F/BGEF)
Used to enter the energy efficient mode.
Under cooling mode, press this button, the
remote controller will adjust the temperature
automatically to 24 C, fan speed of Auto to
save energy(but only if the set temperature
is less than 24 C). If the set temperature is
between 24 C and 30 C, press the ECO
button, the fan speed will change to Auto,
the set temperature will remain unchanged.
COOL
,
O O
DRY
,,
,,
O
O
,,
HEAT
,,
,,
FAN
1
2
Operation of buttons
Temp
1
3
4
5
6
Mode Fan
ECO
OK
Options
Timer
Turbo LED
Fav.
7
RG70F/BGEF
2
10
11
12
13
NOTE:
Pressing the ON/OFF button, or modifying
the mode or adjusting the set temperature to
less than 24 C will stop ECO operation.
Under ECO operation, the set temperature
should be 24 C or more. it may result in
O
O
insufficient cooling. If you feel uncomfortable,
just press the ECO button again to stop it.
5
Timer Button
Press this button to initiate the auto-on/
auto-off time sequence.
6
Turbo Button
The TURBO function makes the unit work
extra hard to reach your present temperature
in the shortest amount of time possible.
When you press the TURBO button in
8
9
COOL mode, the unit will blow cool air
with strongest wind setting to jump-start
the cooling process.
When you press the TURBO button in
HEAT mode, for units with Electric heat
elements, the Electric Heater will activate
and jump-start the heating process.
7
LED Button
If you are sensitive to light when you go to
sleep, you can press the LED button to turn
off the LED display on the indoor unit. Press
the button again to turn it back on.
Fan Button
8
Used to select the fan speed in four steps:
AUTO LOW MED HIGH
NO TE：
You can not switch the fan speed in AUTO
or DRY mode.
Hold down this button for at least 2 seconds
to activate/cancel Silent mode. Due to low
frequency operation of compressor, it may result
in insufficient cooling and heating capacity
(applicalbe to the air conditioner with Silent
feature only)
Press Fan, MODE, Sleep, ON/OFF ,ECO or
Turbo button will cancel the Silent function.
Operation of buttons
Temp
1
3
4
5
6
Mode Fan
Sleep
OK
Options
Timer
Turbo LED
Fav.
7
RG70C/BGEF
RG70C1/BGEF
Swing Button
9
Used to stop or start horizontal louver movement or set the desired up/down air flow
direction. The louver changes 6 degree in
angle for each press. If keep pushing more
than 2 seconds, the louver will swing up and
down automatically.
10
OK Button
Used to confirm the optional fucntions.
11
Swing Button
Used to stop or start vertical louver movement
and set the desired left/right air flow direction.
The louver changes 6 degree in angle for each
press. If keep pushing more than 2 seconds,
2
8
9
10
11
12
13
the louver will swing left and right automatically.
12
Options Button
Press this button to select the air conditioner
function in a sequence of following:
Fresh
Press the Options button to select the desired
function, the selected symbol will flash on
the display area, then press the OK button
to confirm.
FRESH function( )
When the FRESH function is initiated, the
Ionizer/Plasma Dust Collector(depending on
models) is energized and will help to
remove pollen and impurities from the air.
FOLLOW ME function( )
When the Follow Me func ti on i s ac tivated,
the remote display is a ct ua l te mperature
at its location. Th e remote control will sen d
this signal to the air co nd it io ner every 3
minutes interval un ti l pr es s the FOLLOW
ME button again.
Comfort function( )
When the Comfort func ti on i s ac tivated,
the air conditioner w il l be s et a t 23 C
automatically. It is not available under
fan mode.
Follo w me
Comfo rt
Self cl ea n
O
3
4
Loading...