Middle Atlantic LL-VWM-36S-42SP Instructions

use vertical
channels or
angles to
lace cable
bundles from
top to bottom

Installation Instructions

Lever L ock™ Series

use horizontal channels
in the top of the rack
to manage cables
between bays

install horizontal lacer
bars, angles, and
channels between
vertical Lever Lock
accessories, for strain
relief and cable
management

™

use vertical plates to
mount small devices

install horizontal
Lever Lock
angles, and channels
on any location on
rackrail brackets to
provide offset
cable management

™

lacer bars,

BGR Series Enclosure Options

Lever Lock™ TOOL FREE INTERNAL MANAGEMENT SYSTEM

PATENT PENDING

I-00508 Rev C

Lever Lock ™ OPERATION EXAMPLE S

- Shown here is an example of Lever Lock™ operation
(horizontal installation shown).

- Included with the Lever Lock™ accessory are plastic securing
rivets. See page 3 for rivet installation.

- When using Din Rail, the clip must go to the outside if the rack.

- Face the flanges to the outside of the rack for the most usable

surface (plate and channel).

VERTICAL INSTALLATION

1) Insert the Lever Lock™ accessory into the mating slots in the top rackrail brackets. Ensure the lock
mechanism is installed in the bottom rackrail bracket for proper securement.

2) Fully insert into the top rackrail slots, and then push down into the corresponding slots in the lower
rackrail bracket to lock the accessory into place. The Lever Lock™ will click into place when
engaged.

Page 2