Middle Atlantic DOOR-S16 Users Guide

Instruction Sheet

DOOR-S/DOOR-P

Essex Universal Door Kit

THANK YOU

Thank you for purchasing the Essex DOOR-S / DOOR-P Universal Door Kit. Please read these
instructions thoroughly before installing this product.

NOTE: Essex Locking Side Panels (Side-XX-XX) are required on QAR Series when installing
front or rear doors.

TOOLS REQUIRED

• #2 Phillips Screwdriver

INSTALLATION

1) Pivot lower hinge into rack. (FIGURE A)

2) Pull upper hinge to retract pin and pivot door into rack.

(FIGURE A)

Lower
Hinge

Upper

Hinge Pin

FIGURE A

(QAR AND MMR SHOWN)

Page 1

I-00678 Rev -

DOOR REVERSAL PROCEDURE

1) Remove (2) Phillips head screws securing cam as shown. (FIGURE B)

2) Remove (2) Phillips head screws and (2) washers securing handle as shown. (FIGURE C)

Cam

Washers (2)

Handle

Phillips Head

Screws (2)

Phillips Head

Screws (2)

FIGURE B

3) Rotate handle upside-down and re-install in reverse manner.

4) Lift and twist door hinges to remove
door as shown. (FIGURE D)

5) Re-install door as described in step #1.

GROUNDING AND BONDING

Protective Earth Terminals (PET) are located in backpan
of the wall rack. These terminals are marked with the
symbol Wall rack parts, center section and door, contain
or are provided with bonding points for connection to the
backpan / PET. Protective earth and bonding connections
shall be in accordance with Article 250 of the National
Electric Code.

FIGURE C

FIGURE D

1) Attach bonding wire to bonding points using
hardware kit PET-K-DOOR. (FIGURE E)

Door Bonding

Points (2)

FIGURE E

Page 2

middleatlantic.com/essex

WARRANTY

Middle Atlantic Products (the "Company") warrants the ESSEX DOOR-S / DOOR-P UNIVERSAL DOOR KIT to be free from defects in
material or workmanship for the lifetime of the product.

The Company's entire liability to the purchaser, and the purchaser's (or any other party's) sole and exclusive remedy, under this warranty
shall be limited, at the Company's option, to either (a) return of and refund of the price paid for, or (b) repair or replacement at the
Company's factory of the products purchased, or any part or parts thereof, which the Company has determined to be defective after
inspection thereof at the Company's factory.

This warranty does not cover damage due to acts of God, accident, misuse, abuse or negligence by parties other than the Company, or
any modification or alteration of the products. In addition, this warranty does not cover damage due to improper handling, assembly,
installation or maintenance.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL THE COMPANY BE LIABLE FOR ANY
SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION,
DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF
THE USE OF THE PRODUCTS PURCHASED, EVEN IF THE COMPANY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES. THE COMPANY'S LIABILITY TO THE PURCHASER (OR ANY OTHER PARTY) HEREUNDER, IF ANY, SHALL IN NO
EVENT EXCEED THE PURCHASE PRICE OF THE PRODUCTS PAID TO THE COMPANY.

Corporate Headquarters

Corporate Voice 973-839-1011 - Fax [phone] / International Voice [phone] - Fax [phone]
middleatlantic.com - [e-mail]

Middle Atlantic Canada

Voice 613-836-2501 - Fax [phone] / middleatlantic.ca - [e-mail]

Factory Distribution

USA: NJ - CA - IL Canada: ON - BC

At Middle Atlantic Products we are always listening. Your comments are welcome.

Middle Atlantic Products is an ISO 9001 and ISO 14001 Registered Company.