Microtek GNC M 525M 0605 User Manual

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit.

The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/ 1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1+A2+A3+A4+A11)

P/N: 1104-03-990406

Radio Frequency Interference Statement Warning:

This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

Canadian Doc Notice For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian Department of Communications.

“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class B prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.”

Energy Star Notice

As an ENERGY STAR Partner, Microtek International, Inc. has determined that this monitor meets the ENERGY STAR guidelines for energy efficiency.

Table of Contents

Introduction 1

Product Features...................................................................... 1

Unpacking ................................................................................2

Precautions.......................................................................... .... 2

Cleaning ...................................................................................3

Installation 4

Installing the Monitor ............................................................. 4

Connecting the Monitor.......................................................... 5

Adjusting the Viewing Angle................................. ..... .. ..... ... ... 6

Operating the Monitor 7

How to Use the OSD .................................................. ..............7

Operating Procedure...........................................................7

Adjusting Monitor Display ......................................................8

Auto Adjustment ............................ .. ..... ... ..... . .... .. ..... ... ..... . . 8

Manual Adjustment .............................................................8

The Menu Table .............................. ..... ... ..... .. ... .. ..... .. ..... .........9

Appendixes

A: Specifications....................................................................10

B: Supported Timing..............................................................11

C: Troubleshooting ................................................................12

D: Power Management...........................................................14

E: For Your Safety .................................... ............................. 15

Introduction

Congratulations on the purchase of your new Microtek LCD monitor! Providing a maximum resolution of 1024 x 768 pixels with a flicker-free display at up to 75Hz refresh rate, your LCD monitor offers sharp and vibrant color display without the radiation emission and hazards associated with CRT monitors.

Product Features

• 15.0” TFT active matrix color crystal displays

• Supports XGA resolution of 1024 x 768 pixels

• Wide viewing angle

• Wide tilting angle

• VESA PMS-compliant power saving: Automatically powers down the monitor after a defined period of inactivity

• Digital character smoothing

• Automatic setup

• Ergonomic design: TCO approved

• Compatible with Windows and Macintosh

• Easy-to-use OSD (On-Screen Display)

• Plug & Play: Conforms to VESA standards and supports DDC1/2B specifications

• Multiscan functions of XGA 1024 x 768, SVGA 800 x 600, VGA 640 x 480, 720 x400, and 640 x 350 for a perfect graphics performance

• Extra-slim design to maximize your desk space

Unpacking

Before unpacking your LCD monitor, prepare a stable, level, and clean surface near a wall outlet for your LCD monitor.

1. Set the LCD monitor box in an upright position and open from the top of the box before removing the right/left cushions.

2. Check to see that you have the following accessories shown below:

Note: Remember to save your original box and packaging material in case you need to transport or ship the monitor.

Precautions

• Read all of these warnings and save the manual for later use.

• Follow all warnings and instructions on the product.

• Do not cover or block the vent holes in the case.

• Do not insert sharp objects or spill liquid into the LCD

monitor through the cabinet slots; this may cause accidental fire, electric shock or failure.

• Disconnect the power plug from the AC outlet if you are not

going to use the monitor for an extended period of time.

• Do not attempt to service this product yourself, as opening or

removing the cover may expose you to dangerous voltage points or other risks.

• Do not touch the screen directly with your fingers as you may

damage the screen, and oil from your skin is difficult to remove.

+ 14 hidden pages