Microtek GNC I LIGHTLIDEL 0100 User Manual

& Macintosh

Microtek LightLid
Series Products

Installation and Scanning Guide

This document provides information on how to connect the LightLid to your scanner and how to scan transparent
materials with it.

Installation

Windows

For

1. Unpack LightLid

The LightLid is a scanner accessory that is used to
scan transparent materials with your flatbed
scanner. Before proceeding any further, check to see
that all items are in the package. If any item is
missing, contact Microtek Customer Service.

LightLid

Template

3. Remove the scanner
lid

4.Install LightLid

Insert the two LightLid guide pins into your scanner.

NOTE: Before installing the LightLid, your scanner

should be installed and ready to scan.

2.

T urn off your scanner ,
then computer

Copyright © 2000 Microtek International Inc. I49-02802A, January 2000

5.Connect LightLid to
your scanner

English

Plug the LightLid connector into the 15-pin
Accessory port on the back of your scanner.

7.

Position the template

Place the template on the scanner glass surface. The
clear opening strip should point toward the front of
the scanner.

Deutsch

Français

Accessory Port

Italiano

6.

Peel off the protective
vinyl film

Nederlands

Peel off the protective vinyl film from the back of
the template.

Español

The protective vinyl film covers the template during
shipping and prevents it from being scratched.
When peeling the vinyl film from the template, be
careful not to tear off or bend the template.

Clear opening strip

8.Press the template
against the glass
surface

Press the template all the way around against the
scanner glass bed. This ensures that the template
adheres securely to the glass.

Template should fit snugly
within the scanner glass
surface and not overlap on
the vertical/horizontal rulers.

2