Microtek GNC I ADF650 1102, GNC I ADF651 1102 User Manual

Microtek ADF-650/651

Installing and Getting Started

This document describes the features of the Automatic Document Feeder (ADF-650/

651) and provides information on how to install the ADF-650/651.

Introduction

The ADF-650/651 is an optional sheet feeder accessory for the Microtek ScanMakerseries of flatbed scanners. The ADF-650 is designed for the ScanMaker 5600, ScanMaker 6700, and ScanMaker 6800, while the ADF-651 is designed for the ScanMaker 5800 and ScanMaker 5900.

ADF-650 ADF-651

The ADF-650/651 allows automatic scanning of up to 50 sheets of original scan material from A6 size (4.14" x 5.83") up to legal size (8.5" x 14"). Sheets to be scanned are fed from the feeder's top tray, guided and scanned as they pass the scanner's image sensor, and then exit into the feeder's bottom tray.

Trademarks

Microtek®, ScanMakerTM, and ScanWizardTM are trademarks or registered trademarks of Microtek International, Inc. Macintosh® and Apple® are registered trademarks of Apple Computer, Inc. Windows® is a registered trademark of Microsoft Corporation. All other products or name brands are trademarks of their respective holders.

Important

Documents you scan may be protected under copyright law. The unauthorized use of such documents could be a violation of the rights of the copyright holder. Microtek bears no responsibility for the unauthorized use of copyrighted materials.

The ADF-650/651 mounts onto the scanner in place of the scanner's document cover or Transparent Media Adapter (TMA).

Checking the Package

The ADF-650/651 is packaged as an assembled unit, ready to be mounted on the scanner. After unpacking the ADF-650/651, make sure that the following items are included:

• ADF-650/651 unit

• W arranty Card

• ADF-650/651 Installing and Getting Started document

Installing the ADF-650/651

Follow these steps to install the ADF-650/651:

1. Make sure that your flatbed scanner model has a built-in 15-pin accessory port that is compatible with your ADF-650/651.

2. Make sure your scanner has been installed and works properly .

3 . Power of f your scanner.

4. Remove the scanner cover. Open the cover until it stands vertically to the scanner, then pull upward to remove.

Note: The ADF-650/651 uses the same connector as the Transparency Media Adapter (TMA). If your scanner is equipped with its own TMA (or document cover with TMA combination), disconnect the TMA and remove from the scanner before installing the ADF-650/651.

15-pin Accessory port

5 . Hold the ADF-650/651 firmly on both sides

in a vertical position, with its hinge studs and connector at the bottom. With the feeder vertically positioned on the scanner, carefully align and insert the feeder studs into the hinge slots originally used by the scanner cover (or TMA).

2 Microtek ADF-650/651 Installing and Getting Started

6 . Remove the protective film from the transparent cover of the scan sensor area,

then lower the ADF-650/651.

Protective film

7. Plug the feeder's connector into the 15-pin Accessory port at the back panel of the scanner. Secure the connector by tightening the retaining screws.

15-pin connector

8. Turn on your scanner, and wait for the light on the scanner’s front panel to stop blinking and stay on steady. Your system will detect the scanner with ADF-650/ 651 automatically , indicating that the ADF-650/651 is ready to scan.

Microtek ADF-650/651 Installing and Getting Started 3

+ 5 hidden pages