Microtek GNC HOWTO INSTALLTRANSACCSRY 0600 User Manual

How to Install Y our Scanner Transparency Accessories

How to install the various scanner transparency accessories that come with dual-bed scanners featuring the E.D.I.T technology.

Before proceeding any further with installation or use, check first to see that your package includes the following.

8" x 10" Glass Film Holder

35mm Mounted Slide Template

35mm Filmstrip Template

Main Staging Template

6 x 9 cm Film Template

4" x 5" Film Template

Using the 8" x 10" Glass Film Holder

1. Place the film on top of the Glass Film Holder.

2. Place the vinyl strip on the edges outside the film to secure the film to the holder.

3. Place the Glass Film Holder into the transparency tray of the scanner.

Using the 35mm Mounted Slide Template

1. Insert the individual 35mm slides to be scanned into the 35mm Mounted Slide T emplate.

2. Place the 35mm Mounted Slide T emplate in the Main Staging Template, then put this assembly in the transparency tray of the scanner.

There are two ways to scan transparent film.

• By using the 8" x 10" Glass Film Holder, which is used to scan non-standard-sized transparent film.

• By using the Main Staging T emplate, which is used together with the individual templates to scan a particular type of standard-sized transparent film, such as individual 35mm slides, 35mm filmstrips, 6 x 9 cm film, or 4" x 5" film.

Using the 35mm Filmstrip Template

Using the 6 x 9 cm Film Template

Using the 4" x 5" Film Template

1. Push to open the 5-piece 35mm Filmstrip T emplate.

2. Place the 35mm filmstrip to be scanned in the 35mm Filmstrip Template.

3. Pull to close the 5-piece 35mm Filmstrip T emplate.

4. Place the 35mm Filmstrip Template in the Main Staging Template, then put this assembly in the transparency tray of the scanner.

1. Push to open the 6 x 9 cm Film Template.

2. Place the film to be scanned in the 6 x 9 cm Film Template.

3. Pull to close the template.

4. Place the 6 x 9 cm Film T emplate in the Main Staging Template, then put this assembly in the transparency tray of the scanner.

1. Push to open the 4" x 5" Film Template.

2. Place the films to be scanned in 4" x 5" Film T emplate.

3. Pull to close the template.

4. Place the 4" x 5" Film Template in the Main Staging T emplate, then put this assembly in the transparency tray of the scanner .

Note: When the installation is done, you can refer to a separate printed document (Installing and Getting Started or Step-by-Step Tutorial) included in your scanner package for a more detailed scanning procedures.