Microtek C593 User Manual

C593 15” LCD MONITOR

USER’S MANUAL

ii

Installing The Monitor

Follow these steps to install the monitor,

1. Before you connect the cables,make sure that the monitor and the
system unit power switches are OFF.

2 . Please follow the following drawing to remove the plastic back over in

order to connect the signal cable and power cable.

3. Plug one end of the 15pin signal cable to the monitor and the other
end to the video signal connector at the rear of the system. Tighten
the two screws on the cable connector on both ends, otherwise the
screen will be abnormal and LED light is yellow color, not the normal
green color.

4. Connect the power to the monitor through the AC/DC adapter .

5. Connect the power cord on the AC outlet, see the below.

iii

Content

Operating Instructions ............................................................................ iv

Safety Precautions ...................................................................................v

Care and Maintenance ........................................................................... vi

Control Functions .....................................................................................1

Adjustment Procedure .............................................................................2

Auto-Adjustment..............................................................................2

RGB Adjustment ................................................................................3

Contrast Value Adjustment ........................................................3

Color Balance .............................................................................3

Geometry Adjustment ......................................................................4

Vertical & Horizontal Position Adjustment................................4

Viewer Screen Size Adjustment ...............................................4

Phase Adjustmentt.....................................................................4

Multilanguage Support .....................................................................5

DOS Txt/GFX. ....................................................................................5

Color Temperature ............................................................................5

Brightness Adjustment ..................................................................... 5

Understanding the Display Resolution Setting ...............................5

General Specifications .............................................................................6

General Performance ..............................................................................7

iv

Operating Instructions

Thank you for purchasing this high-resolution multi-scan color monitor. Please read
this guide thoroughly before installation.

FCC RADIO FREQUENCY INTERFERENCE STATEMENT WARNING:
(FOR FCC CERTIFIED MODELS)

This monitor has been tested and found compliant with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
proper protection against harmful interference to a residential installation. This
monitor generates, uses, and can radiate radio frequency energy. Harmful
interference to radio communication may result if it is not properly installed and
used. However, there is no guarantee that interference will not occur in a particular
installation. If this monitor does cause serious interference to radio or television
reception, resetting the monitor may resolve the problem. Moreover, users are
encouraged to correct interference by doing one or more of the following:

• Reorient or relocate the receiving antenna.

• Move the monitor and the receiver further away from each other.

• Connect the monitor into an outlet on a circuit different from that to which
the receiver is connected.

• Consult your local dealer or a qualified technician.

FCC Warning:

To assure a continued FCC compliance, a user must use a grounded power supply
cord and the provided shielded video interface cable with bonded ferrite cores. Also,
any unauthorized changes or modifications to this monitor will void the user’s
authority to operate this device.

Note: If necessary, shielded interface cables and the A.C. power cord must be used
to meet the emission level limits.

EMI Certification

The Class B digital apparatus meets all requirements of the Canadian Interference­Causing Equipment Regulation. Cet appareil numerique de class B respecte toutes
les exigences du Reglement sur Ic materiel brouilleur du Canada.