Micro Star Co MS6865 Users Manual

MU54G (MS-6865)
Wireless 11g

miniUSB 2.0 Adapter

User’s Guide

i

FCC Caution

1. The device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.

2. FCC RF Radiation Exposure Statement: The equipment complies with FCC
RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body.

3. This Transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.

4. Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate
the equipment.

FCC Statement

This device is intended only for OEM integrators under the following

1) The antenna must be installed such that 20 cm is maintained between antenna

and users, and

2) The transmitter module may not be co-located with any other transmitter or

antenna.

As long as 2 conditions above are met, further transmitter test will not required. However,
the OEM integrator is still responsible for testing end-product for any additional compli­ance requirements required with module installed (for example, digital device emissions,
PC peripheral requirements, etc.).

Important Note

In the event that these conditions can not be example certain laptop configurations or co­location with another transmitter), then the FCC authorization is no longer considered
valid the FCC ID can not be used on the final product. In these circumstances, OEM
integrator will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.

ii

End Product Labeling

This transmitter module is authorized only for use in device where antenna may be
installed such that 20 cm may be maintained between antenna and users (for example
access points, routers, wireless ADSL and similar equipment). The final end product
must be labeled in a area with the following: “Contains TX FCC ID: I4L-MS686

5”.

Manual Information for End Users

The end user must not have manual instructions to remove or install device. The user
manual for end users must include the following information in a prominent location:
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be co-located operating in conjunction with
any other antenna or transmitter.” as a result of e-mail transmission.”

Important Safety Precautions

Always read and follow these basic safety precautions carefully when handling any
piece of electronic component.

1. Keep this User’s Guide for future reference.

2. Keep this equipment away from humidity.

3. Lay this equipment on a reliable flat surface before setting it up.

4. The openings on the enclosure are for air convection hence protects the
equipment from overheating.

5. All cautions and warnings on the equipment should be noted.

6. Never pour any liquid into the opening that could damage or cause electrical
shock.

7. If any of the following situations arises, get the equipment checked by a
service personnel:

Liquid has penetrated into the equipment
The equipment has been exposed to moisture
The equipment has not work well or you can not get it work

according to User’s Manual

The equipment has dropped and damaged
If the equipment has obvious sign of breakage

8. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT
UNCONDITIONED, STORAGE TEMPERATURE ABOVE 60O C OR
BELOW -20OC, IT MAY DAMAGE THE EQUIPMENT.

iii

Introduction

>>> 1.1 MU54G (MS-6865) - Wireless 11g

miniUSB 2.0 Adapter

MSI MU54G (MS-6865) is a miniUSB 2.0 type adapter and
suitable to be embedded in a notebook or PC system. Its auto­fallback data rate and zero-config features provide a transparent
and easy-configured wireless connectivity for end users as con­necting to the LAN backbone.

Compliant with IEEE802.11g, MSI MU54G is a high-efficiency
wireless adapter for wireless networking at home, in office or in
public places. The data rate can be up to 54 Mbps and auto­negotiated to 48, 36, 24, 18, 12, 9, 6Mbps (IEEE 802.11g), or 11,

5.5, 2, 1Mbps (IEEE802.11b).

With MU54G, you can roam between conference room and of­fice without being disconnected the LAN cables; in addition,
sharing files and printers can be easy tasks.

MU54G is available to Microsoft Windows operating systems
(Windows® XP/2000/ME/98SE) and can be integrated into net­working with either Ad-hoc mode (computer-to-computer, with­out an Access Point) or Infrastructure mode (computer-to­access point, an Access Point is required).

1

>>> 1.2 How MU54G Works

Ad-hoc Mode : An Ad-hoc network is a local area network or
other small network, especially one with wireless or temporary
plug-in connections, in which some of the network devices are
part of the network only for the duration of a communications
session. Users in the network can share files, print to a shared
printer, and access the Internet with a shared modem. In this
kind of network, new devices can be quickly added; however,
users can only communicate with other wireless LAN comput­ers that are in this wireless LAN workgroup, and are within
range.

MU54G

Wireless 11g miniUSB 2.0 Adapter

MU54G

Wireless 11g miniUSB 2.0 Adapter

2