Micro Star Co MS6837 Users Manual

COPY Right are reserved by MSI Ver:1.0 Aug 10.05 Rich Jan
Pin definition:
Green pad is on top side and blue pad is on the bottom side
TP1 TP2 TP3 TP4 TP5 TP6 TP7 TP8 TP9 TP10 TP11 TP12
COPY Right are reserved by MSI Ver:1.0 Aug 10.05 Rich Jan
UART_TX UART_RX UART_CTS UART_RTS PCM_SYNC PCM_IN PCM_OUT PCM_CLLK AIO_0 AIO_1 AUX_DAC 3V3
TP13 TP14 TP15 TP16 TP17 TP18 TP19 TP20 TP21 TP22 TP23 TP24
GND GND PIO0 PIO1 PIO2 PIO3 PIO4 PIO5 PIO6 PIO7 PIO8 PIO9
TP25 TP26 TP27 TP28 TP29 TP30 TP31 TP32 TP33 TP34 TP35
PIO10 PIO11 GND ANT GND USBDN USBDP SPI-MOSI SPI-MISO SPI-CLK SPI-CSB
MS6837B dimension (Unit:mil)
COPY Right are reserved by MSI Ver:1.0 Aug 10.05 Rich Jan
Federal Communications Commission (FCC) Statement
RADIO FREQUENCY INTERFERENCE BTA TEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recept ion, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or mo re of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used.
Use only shielded cables to connect I/O devices to this equipment. CAUTION:
1. Any changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in
2.
conjunction with any other antenna or transmitter.
3. The modular transmitter must be labeled with its own FCC ID number, and if the FCC
ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “ Contains Transmitter Module FCC ID:XYZMODEL1” or “Contains FCC ID:XYZMODEL1.”
Loading...