Microsoft RM 986, RM 987 Users Manual

Nokia XXX and Nokia XXX

Dual SIM

Welcome to the
Nokia XXX and Nokia XXX Dual
SIM

Issue 1 EN RM-986 and RM-987

Psst...

This guide isn't all there is...
There's a user guide in your phone – it's always

with you, available when needed. On the start
screen, tap

For the online user guide, even more info, and
troubleshooting help, go to www.nokia.com/
support.

For info about writing text on your phone, see the
user guide in your phone or the online user guide.

This user guide applies to Nokia XXX (RM-987) and
Nokia XXX Dual SIM (RM-986).

For info on Nokia Service terms and Privacy policy,
go to www.nokia.com/privacy.

Care.

Contents

Safety 3

Get started 5

Keys and parts 5

Insert SIM, battery, and memory card 6

Charge the battery 10

Set which SIM card to use (RM-986) 11

Copy contacts from your old phone 11

2

Basics 12

Check your activity 12

Personalise the lock screen 13

Product and safety information 14

Safety

We invite you to read the instructions on this guide before using the
device.

SWITCH OFF IN RESTRICTED AREAS

Switch the device off when mobile phone use is not allowed or

when it may cause interference o r danger, for example, in
aircraft, in hospitals or nea r medical equipment, fuel, chemicals, or
blasting areas. Obey all instructions in restricted areas.

ROAD SAFETY COMES FIRST

Obey all local laws. Always keep your hands free to operate the

vehicle while driving. Your first consideration while driving
should be road safety.

INTERFERENCE

All wireless devices may be susceptible to interference, which

could affect performance.

QUALIFIED SERVICE

Only qualified personnel may install or repair this product.

BATTERIES, CHARGERS, AND OTHER ACCESSORIES

Use only batteries, chargers, and other accessories approved

by Nokia for use with this device. Do not connect incompatible
products.

KEEP YOUR DEVICE DRY

Your device is not water-resistant. Keep it dry.

3

GLASS PARTS

The device screen is made of glass. This glass can break if the

device is dropped on a hard surface or receives a substantial
impact. If the glass breaks, do not touch the glass parts of the device
or attempt to remove the broken glass from the device. Stop using
the device until the glass is replaced by qualified service personnel.

PROTECT YOUR HEARING

To prevent possible hearing damage, do not listen at high

volume levels for long periods. Exercise caution when holding
your device near your ear while the loudspeaker is in use.

SAR

This device meets RF exposure gui delines when used either in

the normal use position agai nst the ear or when positioned at
least 1.5 centimetre (5/8 inch) away from the body. The specific
maximum SAR values can be found in the Certification Information
(SAR) section of this user guide. For more info, go to www.sar-
tick.com.

When a carry case, belt clip or other form of device holder is used for
body-worn operation, it should not contain metal and should provide
at least the above-stated separatio n distance from the body. Note
that mobile devices may be transmitting even if you are not making
a voice call.

4

Get started

Get to grips with the basics, and have your phone
up and running in no time.

Keys and parts

Explore the keys and parts of your new phone.

1Micro-USB connector
2Earpiece
3 Audio connector (3.5 mm AHJ)
4 Volume/Zoom keys
5 Lock/Power key
6Microphone
7 Back key

5

8Touch screen
9 Camera lens. Before using the camera,

remove the protective tape from the lens.
10 Loudspeaker
11 Antenna area

The antenna area is highlighted.
Avoid touching the antenna area while the

antenna is in use. Contact with antennas affects
the communication quality and may reduce
battery life due to higher power level during
operation.

Do not connect products that create an output
signal, as this may damage the device. Do not
connect any voltage source to the audio
connector. If you connect an external device or
headset, other than those approved for use with
this device, to the audio connector, pay special
attention to volume levels.

Some of the accessories mentioned in this user
guide may be sold separately.

Insert SIM, battery, and memory card

Learn how to insert the battery and SIM and
memory cards.

Important: Your device uses a mini-UICC
SIM card, also known as a micro-SIM card.
Use of incompatible SIM cards, or use of SIM
card adapters, may damage the card or the

6

device, and may corrupt data stored on the
card.

Use only compatible memory cards approved for
use with this device. Incompatible cards may
damage the card and the device and corrupt data
stored on the card.

1. Press the back cover with your thumb, carefully
lift the back cover with your fingers, and remove
the cover.

2. If the battery is in the phone, lift it out.

3. Open the SIM holder, and slide the SIM into the

holder with the contact area face down. Close the
holder, and lock it into place.

7

4. Open the SIM2 holder, and slide the second SIM

into the holder with the contact area face down.
Close the holder, and lock it into place.(RM-986)

Tip: To remove the SIM, open the holder,
and slide the SIM out.

5. Insert the memory card into the memory card
slot. Push the memory card in until it locks into
place.

8