Quick Guide
Lumia 650
[ERROR: book part number not defined] Issue
1 EN RM-1150
Keys and parts
1Main camera
2 Audio connector
3Earpiece
4 Front camera
5 Volume keys
6 Power/Lock key
7Microphone
8 Charger connector
9Loudspeaker
10 Flash
Insert the SIM and memory cards
1. Put your finger in the recess at the bottom edge
of the back cover.
2. Press the middle of the back cover, bend the cover
open, and remove it.
3. If the battery is in, put your fingernail in the recess
on its top edge, and lift it out.
4. Push the nano-SIM card into the SIM slot with the
metal contact area down, until you hear a click.
Tip: To remove the SIM, push the card in until it's
released, then pull it out.
Use only original nano-SIM cards. Use of
incompatible SIM cards may damage the card or the
device, and may corrupt data stored on the card.
5. If you have a memory card, slide the card into the
memory card slot.
Replace the battery and back cover
1. Line up the battery contacts, and put the battery
in.
2. Press the top edge of the back cover against the
top edge of your phone, and snap the cover into
place, locking all the hooks around the edges of the
cover.
Switch your phone on and charge
the battery
Note: Your SIM card has an effect on important
settings. Insert the SIM card before switching the
phone on.
1. To switch your phone on, press and hold the
power key until the phone vibrates. It takes a while
for the phone to walk you through the setup and
get all the apps installed. Your phone’s screen may
even be black at times, so wait patiently.
2. When asked, make sure you select your language
and region correctly. You may not be able to
change some of the settings later on.
To charge your phone, plug a compatible charger
into a wall outlet, and connect the cable to your
phone. You can also charge your phone from a
computer with a USB cable, but it may take a longer
time.
If the battery is completely discharged, it may take
up to 20 minutes before the charging indicator is
displayed.