Microsoft NSD-3AW Users Guide

CARK-91USANDH07.26.00.fm Page 0 Wednesday, July 26, 2000 1:56 PM

Complete Car Kit

(CARK-91US/CARK-91H)

For use with Nokia 5100 and 6100 Series

Wireless Phones

0

CARK-91USANDH07.26.00.fm Page 1 Wednesday, July 26, 2000 1:56 PM

Introduction

This installation guide has been prepared to provide the
basic information necessary to install this car kit. This guide
is not intended to be definitive, because different types and
models of vehicles will require different installation work.
The information given is for general guidance only.

The terms of warranty demand that this car kit be installed by
an experienced installation facility. An end user should never
attempt to install this car kit without professional assistance
as the installation requires special tools and knowledge.

Please refer to the phone’s Owner’s Manual for instructions
on the phone’s operation, care and maintenance, including
important safety information.

Note: Read the warnings below before beginning the instal­lation procedure.

WARNINGS

Ensure that the vehicle’s battery is disconnected before

1)

you start the installation procedure, and that it remains
disconnected during the procedure.

Do not smoke or use open flames when working near

2)

the vehicle’s fuel system.

Ensure that the vehicle’s electrical cables, hydraulic

3)

lines, fuel lines and safety equipment are not damaged
during installation.

Ensure that normal control and operation of the vehicle

4)

is not impaired by the installation, particularly the
brakes and steering.

Electronic and other sophisticated systems

5)

(e.g. speed control, abs anti-lock brake, fuel injection,
navigation and air bag systems) are relatively immune
to malfunction caused by nearby radio transmissions.
However, should you experience false operation of
these systems or are in any doubt whatsoever as to
their functionality, please consult the vehicle’s dealer.

1

CARK-91USANDH07.26.00.fm Page 2 Wednesday, July 26, 2000 1:56 PM

The car kit is suitable for use only in vehicles with a

6)

11-32 V negative grounding. Use on other supply vol­tages or alternative polarity will damage the equipment.

The phone should not be left switched on for extended

7)

periods without running the vehicle’s engine. Failure to
comply could drain the vehicle’s battery.

Unpacking

Carefully unpack the equipment and ensure that the follow­ing items are present.

Advanced Cradle MCC-1
RF Adapter AAC-1
Junction Box HFU-2
Power Cable PCH-4J
Mounting Plate MKU-1
Swivel Mount HHS-9
Microphone HFM-8
External HF Speaker HFS-12

Options

External Audio Handset

(included with CARK-91H)

HSU-1

2

CARK-91USANDH07.26.00.fm Page 3 Wednesday, July 26, 2000 1:56 PM

Component Parts

Advanced Cradle MCC-1

The Advanced Cradle firmly holds the phone in a conve­nient place. The Advanced Cradle is attached to the
vehicle’s interior using the swivel mount HHS-9.

RF Adapter AAC-1

The RF Adapter converts the FME connector of the
MCC-1, Advanced Cradle, into a mini-U connector that
attaches to an external antenna.

Junction Box HFU-2

The Junction Box enables the phone to operate in hands­free mode. The unit is attached to the vehicle interior using
the Mounting Plate MKU-1, or the Swivel Mount HHS-9.
A temporary installation can be achieved using cable ties.

Power is supplied from the vehicle’s battery via the Power
Cable PCH-4J. The Junction Box provides the power
supply to the phone via the system connector.

The HF Microphone HFM-8, connects to the MIC socket
and the External HF Speaker HFS-12, connects to the

socket.

Mounting Plate MKU-1 and Swivel Mount
HHS-9

MKU-1 is a fixed position mounting plate. The HHS-9 is a
Swivel Mount which allows for adjustable fixing. Both
mounting plates are interchangeable.

HF Microphone HFM-8

The HF Microphone connects directly to the socket of the
Junction Box HFU-2, marked MIC.

HF Speaker HFS-12

The HF Speaker connects directly to the handsfree unit

socket. Insert the plug into the socket and twist 90°

to lock firmly in place.

3