Microsensys UNI13Q60232X, UNI13Q60USBX Users manual
iID®Reader
User Manual
UNI13-Q60-232 / UNI13-Q60-USB
RFID read/write module
13.56 MHz closed coupling
Contact/Copyright
microsensys GmbH
Office Park im GVZ
In der Hochstedter Ecke 2
99098 Erfurt
Germany
tel: +49 (0) 3 61/5 98 74-0
fax: +49 (0) 3 61/5 98 74-17
e-mail: info@microsensys.de
homepage: www.microsensys.de
Page 2 ©2011 microsensys GmbH User Manual UNI13-Q60-232 / -USB
FCC Compliance Statement
These devices comply with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. These devices may not cause harmful interferences;
2. These devices must accept any interference received, including interference
that may cause undesired operation.
The following figures list the Grant by FCC ID Number for each of the following
devices:
UNI13-Q60-232 FCC ID: ZLCUNI13Q60232X
UNI13-Q60-USB FCC ID: ZLCUNI13Q60USBX
Please refer to the FCC’s website ( http://www.fcc.gov/ ) to view the grant and related
documentation.
CAUTION !
Exposure to Radio Frequency Radiation. The radiated output of this device is far below
the FCC radio frequency exposure limits. Nevertheless, the device shall be used in
such a manner that the potential for human contact during normal operation is
minimized. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20cm (8inches)
during normal operation. These devices may not be co-located with any other
transmitter or transmitter antenna.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interferences when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by Microsensys GmbH could void
the user’s authority to operate the equipment described in the manual.
User Manual UNI13-Q60-232 / -USB ©2011 microsensys GmbH Page 3
Loading...