Microsemi Corporation CHFP6KE90C, CHFP6KE90A, CHFP6KE90, CHFP6KE9.0CA, CHFP6KE85CA Datasheet

MSC1596.PDF ISO 9001 CERTIFIED REV B 3/13/2000

8700 E. Thomas Road
Scottsdale, AZ 85251
Tel: [phone]
Fax: [phone]

BIDIRECTIONAL ALL DIMENSIONS NOMINAL

inches (mm)

FLIP-CHIP DIMENSIONS PAD SIZE & CIRCUIT

UNIDIRECTIONAL ALL DIMENSIONS NOMINAL

inches (mm)

FLIP-CHIP DIMENSIONS PAD SIZE & CIRCUIT

FLIP-CHIP TVS DIODES

CHFP6KE5.0

thru

CHFP6KE170CA

Patented Flip-Chip Series

VBR above 30 V VBR 30V and below

FEATURES

• Unidirectional and Bidirectional

• Fully glass passivated

• 600 watt (10/1000 µs)

• Eliminates wire bonding

• NON Inductive Insertion

• No voltage overshoot

MAXIMUM RATINGS

• Max Junction Temperature: 1500C (with conformal coating)

• Storage Temperature: -55

0

C to +1500C

• Flip-Chip Peak Pulse Power: 600 Watts (10/1000 µs)

• Maximum non-repetitive peak power 600 Watts (10/1000 µs)

• Total continuous power dissipation 2.5 W (with adequate heat

sink @ 75

0

C)

• Turn-on time (theoretical) unidirectional 1X10

-12

• Turn-on time (theoretical) bidirectional 1X10

-9

MECHANICAL

•

Weight: 0.01 grams (approximate)

• Solderable standoff tabs .040X.040X.010

PACKAGING

• Waffle package 50 pices or wafer ring 70 pieces

MSC1596.PDF ISO 9001 CERTIFIED REV B 3/13/2000

CHFP6KE5.0 thru CHFP6KE170CA

ATTACHMENT AND CONFORMAL COATING

INSTRUCTIONS

FOR Flip-Chip COMPONENTS

The .010” thick tab standoffs minimize shorting during attachment; however, minimal
solder/conductive epoxy must be used and carefully controlled to prevent excess
attachment material from wicking up the side of the tab and shorting across the junction.
Maximum recommended solder temperatures are 212 C for IR reflow and 221 C for
vapor-phase reflow. For flip-chip protection, coating material is Stycast ™ 2651-40 low­viscosity epoxy manufactured by Emerson & Cuming. Follow instructions carefully for
preparation of the epoxy to prevent entrapment of air bubbles. Make sure that Flip-Chips
have been baked at 100 C for 15 minutes minimum to out-gas any adsorbed moisture
immediately prior to coating. Epoxy-coating material should be dispensed around the
edges of the chip with an appropriately sized syringe after which epoxy is de-aired to
remove bubbles entrapped beneath the chip. Cure epoxy as instructed by the supplier.

PEAK PULSE POWER Vs PULSE TIME

PEAK PULSE

POWER DERATING

TP – PULSE TIME – SEC

TEMPERATURE °C

P

pp

– PEAK PULSE POWER – kW

Peak Pulse Power (P

PP

) or Current (I

PP

)

In percent of 25° C rating