Microsemi CDLL5518, CDLL5546D Technical data
6 LAKE STREET, LAWRENCE, MASSACHUSETTS 01841
PHONE (978) 620-2600 FAX (978) 689-0803
WEBSITE: http://www.microsemi.com
143
FIGURE 1
DESIGN DATA
CASE: DO-213AA, Hermetically sealed
glass case. (MELF, SOD-80, LL34)
LEAD FINISH: Tin / Lead
THERMAL RESISTANCE: (R
OJEC
):
100 °C/W maximum at L = 0 inch
THERMAL IMPEDANCE: (Z
OJX
): 35
°C/W maximum
POLARITY: Diode to be operated with
the banded (cathode) end positive.
MOUNTING SURFACE SELECTION:
The Axial Coefficient of Expansion
(COE) Of this Device is Approximately
+6PPM/°C. The COE of the Mounting
Surface System Should Be Selected To
Provide A Suitable Match With This
Device.
MAXIMUM RATINGS
Junction and Storage Temperature: -65°C to +125°C
DC Power Dissipation: 500 mW @ TEC= +125°C
Power Derating: 10 mW / °C above TEC= +125°C
Forward Voltage @ 200mA: 1.1 volts maximum
ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise specified.
B-C-D
SUFFIX
CDI NOMINAL ZENER MAX. ZENER MAXIMUM REVERSE MAXIMUM REGULATION LOW
TYPE ZENER TEST IMPEDANCE LEAKAGE CURRENT DC ZENER FACTOR V
Z
NUMBER VOLTAGE CURRENT B-C-D SUFFIX CURRENT CURRENT
VZ@ 1ZT1
ZTZZT
@ 1
ZT
l
R
VR= VOLTS 1
ZM
∆
V
Z
1
ZL
(NOTE 1) (NOTE 2) (NOTE 3) (NOTE 4) (NOTE 5)
NON & A- B-C-D-
VOLTS mA OHMS
µ
Adc SUFFIX SUFFIX mA VOLTS mA
CDLL5518B 3.3 20 26 5.0 0.90 1.0 115 0.90 2.0
CDLL5519B 3.6 20 24 3.0 0.90 1.0 105 0.90 2.0
CDLL5520B 3.9 20 22 1.0 0.90 1.0 98 0.85 2.0
CDLL5521B 4.3 20 18 3.0 1.0 1.5 88 0.75 2.0
CDLL5522B 4.7 10 22 2.0 1.5 2.0 81 0.60 1.0
CDLL5523B 5.1 5.0 26 2.0 2.0 2.5 75 0.65 0.25
CDLL5524B 5.6 3.0 30 2.0 3.0 3.5 68 0.30 0.25
CDLL5525B 6.2 1.0 30 1.0 4.5 5.0 61 0.20 0.01
CDLL5526B 6.8 1.0 30 1.0 5.5 6.2 56 0.10 0.01
CDLL5527B 7.5 1.0 35 0.5 6.0 6.8 51 0.05 0.01
CDLL5528B 8.2 1.0 40 0.5 6.5 7.5 46 0.05 0.01
CDLL5529B 9.1 1.0 45 0.1 7.0 8.2 42 0.05 0.01
CDLL5530B 10.0 1.0 60 0.05 8.0 9.1 38 0.10 0.01
CDLL5531B 11.0 1.0 80 0.05 9.0 9.9 35 0.20 0.01
CDLL5532B 12.0 1.0 90 0.05 9.5 10.8 32 0.20 0.01
CDLL5533B 13.0 1.0 90 0.01 10.5 11.7 29 0.20 0.01
CDLL5534B 14.0 1.0 100 0.01 11.5 12.6 27 0.20 0.01
CDLL5535B 15.0 1.0 100 0.01 12.5 13.5 25 0.20 0.01
CDLL5536B 16.0 1.0 100 0.01 13.0 14.4 24 0.20 0.01
CDLL5537B 17.0 1.0 100 0.01 14.0 15.3 22 0.20 0.01
CDLL5538B 18.0 1.0 100 0.01 15.0 16.2 21 0.20 0.01
CDLL5539B 19.0 1.0 100 0.01 16.0 17.1 20 0.20 0.01
CDLL5540B 20.0 1.0 100 0.01 17.0 18.0 19 0.20 0.01
CDLL5541B 22.0 1.0 100 0.01 18.0 19.8 17 0.25 0.01
CDLL5542B 24.0 1.0 100 0.01 20.0 21.6 16 0.30 0.01
CDLL5543B 25.0 1.0 100 0.01 21.0 22.4 15 0.35 0.01
CDLL5544B 28.0 1.0 100 0.01 23.0 25.2 14 0.40 0.01
CDLL5545B 30.0 1.0 100 0.01 24.0 27.0 13 0.45 0.01
CDLL5546B 33.0 1.0 100 0.01 28.0 29.7 12 0.50 0.01
NOTE 1 No Suffix type numbers are +20% with guaranteed limits for only V
Z
, lR, and VF.
Units with “A” suffix are +
10% with guaranteed limits for VZ, lR, and VF. Units with
guaranteed limits for all six parameters are indicated by a “B” suffix for +
5.0% units,
“C” suffix for+
2.0% and “D” suffix for +1.0%.
NOTE 2 Zener voltage is measured with the device junction in thermal equilibrium at an ambient
temperature of 25°C +
3°C.
NOTE 3 Zener impedance is derived by superimposing on 1
ZT
A 60Hz rms a.c. current equal to
10% of1
ZT.
NOTE 4 Reverse leakage currents are measured at VRas shown on the table.
NOTE 5 ∆VZis the maximum difference between VZat lZTand VZat lZLmeasured
with the device junction in thermal equilibrium.
•
1N5518BUR-1 THRU 1N5546BUR-1 AVAILABLE IN JAN, JANTX AND JANTXV
PER MIL-PRF-19500/437
• ZENER DIODE, 500mW
• LEADLESS PACKAGE FOR SURFACE MOUNT
• LOW REVERSE LEAKAGE CHARACTERISTICS
• METALLURGICALLY BONDED
1N5518BUR-1
thru
1N5546BUR-1
and
CDLL5518 thru CDLL5546D
MILLIMETERS INCHES
DIM MIN MAX MIN MAX
D 1.60 1.70 0.063 0.067
F 0.41 0.55 0.016 0.022
G 3.30 3.70 .130 .146
G1 2.54 REF. .100 REF.
S 0.03 MIN. .001 MIN.
144
CDLL5518 thru CDLL5546D
.1 .2 .5 1 2 5 10 20 50 100
OPERATING CURRENT I
ZT (mA)
FIGURE 3
ZENER IMPEDANCE VS. OPERATING CURRENT
ZENER IMPEDANCE Z
ZT (OHMS)
1000
500
400
300
200
100
50
40
30
20
10
5
4
3
2
1
28 VOLT
6.8 VOLT
11 VOLT
0 25 50 75 100 125 150 175
T
EC
, End cap temperature (C°)
POWER DERATING CURVE
500
400
300
200
100
0
Pd, Rated Power
Dissipation (mW)
FIGURE 2
Loading...