Micromega WM-10 User Manual

USER GUIDE

WM-10

Dear customer,
Thank you for choosing MICROMEGA’s WM-10 Wi-Fi music streamer.
WM10 fully complies with the IEEE 802.11n standard which offers a greater range than the previous norms.
The WM-10 allows you to listen to music stored on your computer using your hifi system. Please take time to carefully read through this

user guide and learn how to get the most out of your player.

INITIAL CHECKS CONNECTIONS

Check the state of the packaging before opening. If you have
any doubts about this, contact your dealer immediately.

Using the supplied power cord, connect the device to the mains
and check that the On-Off switch is in the O position.

Connect the stereo output on the WM-10 to a line input on your
hi-fi system.

UNPACKING

Take special care when removing the device from its box. We
advise you to store the packaging safely in a dry place for
further use. If the device needs to be sent back to your dealer at
a later point, it must be sent back in its original packaging. This
is an essential warranty condition.

A digital output is also available if required. However, it is worth
noting that endless listening sessions have proved that sound
quality is better when using the stereo output.

SWITCHING THE DEVICE ON

When all of the connections have been made, you can switch
the device on by using the On-Off switch, located to the left of
the power socket on the rear panel. On the front panel, a blue
LED lights up for a second then switches to red, indicating that
the initialization procedure is under way.

ACCESSORIES

You will find the following accessories inside the box:

− A power cord

− A stereo cable

When the WM-10 is ready to be used, the LED turns blue ­please be patient, this operation may take a few minutes.

MAINS VOLTAGE

QUICK AIRDREAM NETWORK CONNECTION

- Check that the mains voltage indicated on the identification
label, which can be found both on the side of the box and
underneath the device, corresponds to the mains voltage in
your home.

The WM-10 is already configured to ensure easy installation.
The procedure is slightly different according to whether you
have a MAC or a PC. However, your computer must be Wi-Fi
compatible.

- If it does not correspond, contact your authorized dealer.
For Macintosh users:

INSTALLATION

- Your computer will detect the AIRDREAM network as soon as
it is available. Connect your computer to this network by using
the default user password “airdream”.

In order to make the most of all of the features of this device, it
is important to install it correctly.

We advise you, as far as possible, to install the WM-10 on a
shelf in a hi-fi rack or cabinet.

For PC users:
When the WM-10 is ready, use your computer to detect the

wireless networks available. By default, the name of the Wi-Fi
network is AIRDREAM and the default password is
“airdream”. If this network figures in the list, select it and
connect your computer.

Due to the nature of Wi-Fi technology, there are other elements
which also need to be taken into account:

- Position your music streamer in an open area,

avoiding obstructions such as large pieces of furniture or walls.
Avoid placing it in areas surrounded by metallic surfaces on 3 or
more sides.

If for any reason the WM-10 AIRDREAM network does not
figure in the list, check that the Wi-Fi connection is active.
Refresh the list of available networks and check the status of
the LED on the WM-10: it should be blue.

Try to position it at least 8m away from a microwave
oven, DECT (2.4GHz) cordless telephones or any other source
of interference.