Microlab Electronics HIVE User Manual

80- D26-9 7-000 1(US) -01 201 7-9-2 6
Hive
FCCI D:OR8 -HIVE IC: 21231 -HIVE
INSTRUCTIONS
ANT SAFETY
T
IMPOR
Read these instructions – All the safety and
1. operating instructions should be read before this product is operated. Keep these instructions – The safety and
2. operating instructions should be retained for future reference. Heed all warnings –
3. appliance and in the operating instructions should be adhered to. Follow all instructions –
4. instructions should be followed. Do not use this apparatus near water –
5. appliance should not be used near water or moisture – for example, in a wet basement or near a swimming pool, and the like.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacture’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Only use attachments/accessories specified by the manufacturer
10. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart or rack is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over
1. Unplug the apparatus during lightning storms or
1
when unused for long periods of time.
12. Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus has been exposed to rain or moisture, does not operate normally been dropped.
13. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. to dripping or splashing and that objects filled with liquids, such as vases, shall not be placed on apparatus.
14. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
ARNING:
15. W battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like.
All warnings on the
All operating and use
The
.
.
, such as power
, or has
The apparatus shall not be exposed
The battery (battery or batteries or
RISK OF ELEC TRIC SH OCK
DO NOT OPEN
ATTENTION :RISQU EDECHOCE LECTR IQUE- NEPASOUVRIR
16.This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage”within the product’ s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Warning: To reduce the risk of electric shock, do
not remove cover (or back) as there are no user-serviceable parts inside. Refer servicing to qualified personnel.
The exclamation point within an equilateral
triangle is intended to alert the user to the presence of important operating and maintenance instructions in the literature accompanying the appliance.
17. Correct Disposal of this product. This
marking indicates that this product should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
18. No naked flame sources, such as lighted candles, should be placed on the apparatus.
19. Replacement parts - When replacement parts are required, ensure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.
20. Try to install the product near a wall socket or extension cord and shall be easily accessible.
21. The highest environmental temperature suitable for this product is 0 to 35 for indoor use only .
FCC and Canada EMC Compliance Iinformation
This device comp lies with part 15 of the FCC Rules . Operation is subject to the fo llowing two conditions: (1 ) This
interference t hat may cause undesired oper ation.
Note: This equipm ent has been tested and found to c omply with the limits for a Clas s B digital device, pursuant
to part 15 of the FCC Ru les. These limits are designe d to provide reasonable prot ection against harmful
interference i n a residential installati on. This equipment generate s uses and can radiate radio fre quency energy
and, if not instal led and used in accordance wit h the instructions, may caus e harmful interference to ra dio
communicatio ns. However, there is no guarantee t hat interference will not oc cur in a particular installa tion. If this
equipment does c ause harmful interferenc e to radio or television recep tion, which can be determine d by turning
the equipment off a nd on, the user is encouraged to t ry to correct the interferen ce by one or more of the following
measures:
Reorient or relocate the receivi ng antenna.
Increase the separation betwee n the equipment and receive r.
Connect the equipment into an outl et on a circuit different from th at to which the receiver is conn ected.
Consult the dealer or an experienc ed radio/TV technician for h elp.
Any Changes or mod ifications not expressly a pproved by the party respons ible for compliance could vo id the
user's authori ty to operate the equipment.
The device has bee n evaluated to meet general RF e xposure requirement. The de vice can be used in portable
exposure condi tion without restriction .
This device comp lies with Industry Canada li cence-exempt RSS standar d(s).
Operation is sub ject to the following two cond itions: (1) This device may not c ause interference, and (2) Thi s
device must acce pt any interference, inclu ding interference that may c ause undesired operation o f the device.
Le présent appar eil est conforme aux CNR d'Ind ustrie Canada applicable s aux appareils radio exempt s de
licence. L'exp loitation est autorisée au x deux conditions suivante s:
(1) l'appareil n e doit pas produire de brouill age, et
(2) l'utilisat eur de l'appareil doit accep ter tout brouillage radioé lectrique subi, même si le bro uillage est
susceptible d' en compromettre le fonctio nnement.
l
anua
M
Loading...