MicroIQ UT, CT, ST User manual

MODELS: UT CT ST
Station mode instructions
For Office furniture, storage cabinets, lockers, safes, vaults, secured enclosures
Getting Started
1. Station mode (repeated use with the same code)
2. Locker mode (use with a temporary code) The operating mode is specified at the time of order. To determine which operating mode the lock is in, remove the battery, press and
release the program button, and reinsert the battery. Note the color sequence of the LED flashes when the battery is reinserted:
(green, red, yellow) indicates station mode (green, yellow, red) indicates locker mode
Program button:
Initiate the lock programming mode by pressing the front thin edge of the black button inward toward the mounting surface the Micro IQ is mounted to.
Infrared Receiver:
The Infrared Receiver will receive a signal from an electronic TriTeq key fob when it is pointed at the receiver located behind the Program button. The Program button is slightly opaque so the key-fob signal will penetrate the button.
Knob:
To move the lock mechanism 90 or 180 degrees clockwise or counterclockwise from the locked and unlocked states.
Multiple levels of access:
1.Master code and/or blue control key fob The factory master code is: 135243
2.Supervisor code and/or black key fob The factory supervisor code is: 123
3.User code and/or black key fob
Note: The MicroIQ is pre-programmed with a factory master code and a factory supervisor code.
Operation: Unlock with a code by entering a valid code. The green LED will illuminate. Turn the knob to unlock.
To lock, turn the knob to align the knob pointer with the lock icon on the keypad.
Programming Chart Symbols:
P = press program button
- Solid color indicates LED is lit
- Indicates LED is flashing
(Nx) – indicates flashes N times 1,2,3,4,5 = Indicates the button number to press Note: If any there are any errors in executing the steps below or too much time elapses between the steps, (3x) and the lock will exit the programming mode.
Loading...
+ 4 hidden pages