microHAM offers for this product 3 years time warranty and 30 day full money back less shipping.
The product must not be modified in any way, except configuration, otherwise the warranty voids.
microHAM assumes no responsibility for damages on other devices or injuries on persons, as a
consequence of using our products.
w Insert CR-ROM to the CD drive
w Run "urouter_release_xx_xx.exe" (xx_xx is version) from CD to start the installation and launch Router.
w Connect USB cable to the micro KEYER. Other cables left unconnected
w Plug second end of the USB cable to the computer USB port and install USB driver from location:
C:\Program Files\microHAM\driver\d2xx
w You should see tab with micro KEYER statement with yellow X mark
w Plug audio cables to the sound card and to the micro KEYER rear panel jacks. Computer Line Out to
micro KEYER Line Out, computer Line In to MK Line In and computer Mic In to MK Mic In.
w Turn OFF your radio
w Plug DB37 radio cable to the micro KEYER and other ends of the radio cable to the appropriate radio
jacks.
w Turn radio ON.
w Within three second you should see single flash of green FSK Led at the MK front panel and a few
seconds you should see Green OK mark at Router software next micro KEYER statement tab.
w Congratulation ! You can start playing with micro KEYER, but better read this manual now :-)
Power consumption: USB side - up to 100mA; Transceiver side up to 200mA at 13.8V (max. 16V)
Radio Port: RXD, TXD, (RTS, CTS) max. 19200 Bd
- levels: TTL, inverted TTL, open collector bus, RS232
CW: open collector, max 30V/400mA
FSK: open collector, max 30V/400mA
- supported 5/6/7/8bit data length, 1/1.5/2 stop bit, up to 300 Bd
PTT1: open collector, max 30V/100mA
PTT2: open collector, max 30V/400mA
PA PTT: selectable by rear panel switch
- open collector, max. 48V/1.5A
- relay contact, max. 125VAC/2A 60VDC/2A
Foot Switch: input, active when closed to ground, max. 5 mA
Radio AF OUT: 600 Ohm, max 1Vpp
3dB bandwidth: 0.2 - 6KHz typically
Insertion loss: 9dB typically (4-6dB attenuator)
Computer LINE OUT: 600 Ohm, max 1Vpp
3dB bandwidth: 0.2 - 6KHz typically
Insertion loss: 9dB typically (4-6dB attenuator)
Computer MIC IN: signal and signal ground directly switchable to the MICROPHONE input (jumper
selectable preamplifier for dynamic microphones)
Radio MIC IN: signal and signal ground directly switchable to the MICROPHONE input. All others wires are
routed from RJ45 to the radio microphone input. Microphone works with all his functions as if were plugged
straight to the radio.
Dimensions: W 175mm (6.89") x H 44mm (1.73") x D 85mm (3.35")
Weight: 1100g (2.43lbs)
6. REQUIREMENTS
Minimal
PC compatible computer with Win98SE, 48MB RAM, sound card, CD-ROM, USB1.1 port, transceiver,
logger or control software
Recommended
PC compatible computer with WinXP Home or higher, 256MB RAM, sound Card, CD-ROM, USB2.0 port,
transceiver with computer port, FSK port, CW paddle, PS/2 keypad, logger or control software
w Dual color LEDs for easy visual feedback of CW/FSK and PTT1/PTT2
w Metal/Aluminum case, powder coated and silk screened
w Free firmware/software upgrades via Internet
8
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.