Page 1
ON, A
OF
ANTY IS
E
authorized
-in the
-
1 year
2 years
2 years
Duration
SERIAL NUMBER ON TH
at INTIRION by calling 1
1-800-263-2629 Canada Customers
1-800-637-7567 U.S. Customers
FE PLUG® A PRODUCT OF INTIRION CORPORATI
ITED STATES POSSESSIONS AND/OR DOMINIONS
AND USED IN THE UNITED STATES AND
MISSING. THIS WARR
ECOME INVALID IF ANY
, nor any 50/60 cycle or 60/50 cycle
providers will make every reasonable effort to
for repair, at the discretion of INTIRION.
-800-263-2629 if you are located in
authorized service provider
authorized service
Refrigerator/Freezer Residential Limited Warranty
Product of INTIRION™ Corporation
PO Box 1778, Guelph, Ontario, Canada N1H 6Z9
2 Annette Road, Suite 3, Foxborough, MA 02035
DIVISION OF DANBY PRODUCTS LIMITED
MICROFRIDGE® WITH SA
original sales slip or bill of sale) will be necessary to initiate a warranty claim.
The warranty period begins on the date of sale and proof of that date (evidenced by an
replacement of the product or its components.
specifically denies responsibility for any consequential damages beyond the repair or
person, agency, distributor, dealer, or company. INTIRION assumes no liability and indeed
This is the entire INTIRION warranty and it may not be changed or amended by any
THE UNITED STATES.
CANADA EXCEPT FOR UN
FOR INTIRION PRODUCTS PURCHASED
PRODUCT IS ALTERED, REPLACED, DEFACED OR
THIS WARRANTY WILL B
broken or marred cabinet, misuse, neglect, accident, fire, flood or other acts of nature.
and/or maintenance, customer adjustments that are not covered in the instruction booklet,
conversions, damage caused by failure to follow the owner’s manual as to adjustments
performed by an
and does not guarantee or warrant any repairs and/or replacement parts not supplied or
microwave oven is specifically excluded from this warranty. INTIRION assumes no liability
Damage initiated by spark fires caused by using inappropriate material inside the
customer dissatisfaction should be promptly reported to INTIRION.
enhance the image and reputation of INTIRION and its products. Inadequate service or
further expects that all
service providers. INTIRION expects prompt, courteous and efficient service. INTIRION
MicroFridge® with Safe Plug® warranty services are performed by INTIRION
appliance to an authorized service provider
will diagnose the problem and either replace or the original purchaser will carry
Canada. INTIRION offers a quick response customer service program. Customer service
800-637-7567 if you are located in the U.S., and 1
All requests for service should be directed to Customer Service
Microwave oven and refrigerator/freezer mechanical components
Refrigerator/freezer sealed system and compressor
Microwave oven magnetron
Subassembly
purchaser.
warrants its products and parts against defects in materials or workmanship to the original
these products. INTIRION takes pride in its product and manufacturing standards and
INTIRION, a division of Danby Limited, is pleased to provide a comprehensive warranty on
-
⑫
⑪
-prong grounded outlet on the Microwave Oven. (This is the only method that
Your refrigerator must be grounded. Use a 115 volt, 60 Hz outlet. If you are using
(not shown).
Since cold air flows through this outlet into the refrigerator,
10.3RMF4R / 10.3LMF4R/ 10.3RMF4RW/ 10.3LMF4RW
⑬
⑥
④
②
⑤
①
⑩
MicroFridge® with Safe Plug®, a
refrigerator because the electricity will be cut off during this period.
Oven is working. W AIT at least three (3) minutes after using the Microwave Oven before plugging in the
When you start this refrigerator from the Microwave Oven Power Supply: Do NOT plug in while the Microwave
OR WIRING OF THE REFRIGERATOR.
SEVERE OR LETHAL SHOCK IN THE EVENT OF A SHORT CIRCUIT OF AN ELECTRICAL COMPONENT
UNLESS THE ABOVE GROUNDING METHOD IS FOLLOWED, YOU ARE NOT PROTECTED AGAINST
complies with the National Electric Code, local codes and ordinances.)
Use a 3-prong plug with the 3
pending Safe Plug® technology to limit electrical draw. Do not use an extension cord.
120 V/60 Hz outlet located on the back of the Microwave Oven in order to take advantage of patent
this refrigerator as part of a MicroFridge® with Safe Plug® combination appliance, you must use the
flammable materials.
Do not operate your refrigerator near flammable materials such as gasoline. Do not use for storage of
CAUTION:
13. Adjustable Feet
12. 2-Liter Door Shelf
11. Full-Width Door Shelves
10. Ice Cube Tray
9. Evaporating Tray:
8. Interior Light Switch
7. Interior Light
6. Glass Shelf with Crisper
5. Freezer Shelf
4. Slide-Out Shelves
3. Temperature Controls
2. Suction Inlet
be sure to avoid blocking it with stored food.
1. Discharge Outlet for Cold Air:
③⑦⑧
Parts and Features
INSTRUCTION
MANUAL
10.3RMF4R, 10.3LMF4R, 10.3RMF4RW,10.3LMF4RW
REFRIGERATOR/FREEZER
by INTIRION
Part No. 8336460124300
PR1081MF*
Printed in Mexico
What is Safe Plug® Technology?
MicroFridge® with Safe Plug® combination appliances utilize Safe Plug® technology, a
revolutionary, patented design, to conserve electricity and reduce potential fire hazards that can be
caused by overloaded circuits. This technology, built into the microwave, works by temporarily
shutting off the power to the refrigerator and charging outlets when the microwave is in use. When
the microwave is finished, power to the refrigerator and charging outlets resumes. Engineered with
unique one-plug-to-the-wall operation, our combination appliances never draw more than 11-15
amps of current.
MicroFridge® with Safe Plug® uses patented intelligent load monitoring technology to control the
microwave, refrigerator and extra outlets. The two charging outlets are designed to conveniently re
-charge smart phones, tablets, laptops or similar low power devices.
IMPORTANT WARNING
An empty refrigerator is a very dangerous
attraction to children. Remove the gasket, latches,
lids or doors from unused appliances, or take
some other action that will guarantee the
appliance harmless.
DANGER: Risk of child entrapment. Before you
throw away your old refrigerator:
• Take off the doors.
• Leave the shelves in place so that children may
not easily climb in.
DON’T WAIT! DO IT NOW!
For your protection in the event of theft or
loss of refrigerator, fill in spaces provided
below.
Model and Serial Numbers are indicated
on the inside right liner of the refrigerator.
MODEL No. ____________________
SERIAL No. ____________________
ATTENTION
02.10.2014
Page 2
Where to Place Your MicroFridge® with Safe Plug®
1. This product is designed for free-standing installation only.
2. Select a location with a strong level floor. If the floor is not quite level, adjust the
height of the front legs accordingly. Do not place
anything under either one of the front legs or the
rear of the unit.
3. A minimum of 2 inches of clearance must be
provided between the rear condenser and the wall.
Providing greater rear wall clearance when space
allows in order to improve air circulation is
recommended; in addition, leave unobstructed
space above the refrigerator and both sides.
4. Avoid any direct sunlight and heat. Direct sunlight
may affect the enamel coating. Heat sources nearby
will cause higher electricity consumption.
5. Avoid very moist places. Too much moisture in the
air will cause frost to form very quickly on the
evaporator and the refrigerator will have to be defrosted more frequently.
6. Your refrigerator is equipped with a three-prong plug and is grounded to
eliminate electrical hazards. In order to make it more effective, it must be plugged
into a grounded electrical outlet.
7. Plug your refrigerator into the back of the microwave.
Test Run Your Refrigerator
Before using your refrigerator, clean it and test run it to see if it is operating
properly. If it is not, then check your electrical source. If you cannot locate the
source of the problem, contact your dealer.
1. Set the temperature control knob to the “OFF” position and then plug the AC
cord into an electrical outlet of 115 volt, 60Hz. The compressor motor should
not run.
2. Set the temperature control knob to the “MAX” position and let the
refrigerator operate for 20 minutes. The freezer should get slightly frosted
and the motor should run smoothly with a soft hum.
3. Rotate the temperature control knob counter-clockwise toward the “MIN”
position. Before the pointer of the temperature control knob reaches the
“MIN” position, the compressor motor should turn off.
Temperature Control
You can control the temperature inside your refrigerator by turning the
temperature control dial. Higher numbers mean greater cooling power; smaller
numbers mean less cooling power.
Refrigerator
Set the temperature control dial to 3 for optimum
refrigeration effects under normal conditions.
Set the temperature control dial to MAX only when
rapid cooling in your refrigerator is necessary. Be
sure to set it back to 3 later on.
Freezer
For ordinary use, set the temperature control in the
MED position. For rapid freezing of foodstuffs or to
make ice cubes in a hurry, set the knob to the
COLD position. Do not forget to set the
temperature control back to MED once the rapid freezing process has been
completed.
Important
Do not operate your refrigerator for more than six hours at a stretch with the
temperature control dial set to 5 or MAX. At this setting, the compressor
will run continuously. Consequently, foodstuffs stored in the refrigerator
compartment will be frozen and frost will form on the cooling (evaporator)
unit.
At the control dial setting of 1, the freezer compartment temperature will not
remain at a sufficiently low level for ice cream and frozen foods.
Sound of Flowing Is Noticeable
This sound is caused by the refrigerant flowing into the refrigerating device. It
does not denote a malfunction.
How to Remove Ice Cubes from the Tray
The ice cube tray is flexible. Twist the tray to remove the
ice cubes. If the ice cube tray is frozen hard to the surface,
do not use a knife or other metal instrument to remove it
Cleaning and Maintenance
Your refrigerator does not require any maintenance.
Turn off your refrigerator and remove all food, shelves, trays, etc. Wash the
interior liner with a solution of two tablespoons of baking soda and a quart of
warm water. Then, rinse and wipe it out. Do not use soaps, detergents,
scouring powders, spray cleaners or the like for cleaning the interior liner.
It may cause odors in the refrigerator compartment.
Wash the ice cube trays, drip tray and shelves in a mild detergent solution and
dry with a soft cloth. Normal appliance spray cleaners may be used for the
exterior only.
Use only mild soap and water to clean the door gasket.
Never use acid, chemical thinners, gasoline, benzene or the like to clean any
part of the refrigerator. Boiling water and benzene may deform or damage the
plastic parts.
Cleaning the Evaporating Tray
Since dust accumulated on the evaporating tray
will decrease the evaporation efficiency, remove
the tray to clean.
The evaporating tray is set on the back of the
refrigerator. To remove tray, remove screws and
pull tray away from the unit. After cleaning make
sure to put the tray securely back in place
otherwise defrosted water may spill or the
evaporation process may be hindered.
Hot-Line
With the refrigerator/freezer in operation, it is possible that the
cabinet will feel warm at the front edges. This does not
indicate trouble. It is attributable to the hot gas line design.
This prevents moisture from accumulating and has nothing to
do with the storage temperature inside.
ATTENTION
If the unit is turned off or unplugged, YOU MUST ALLOW THREE (3) MINUTES
BEFORE RESTARTING OR REPLUGGING THE UNIT. The unit will not start if you
attempt to restart it in less than three (3) minutes.
Changing Door Hinge Location
The door of the refrigerator can be hinged on either side so that the direction they open in can be
chosen to suit the place of installation. Refer to the disassembly diagram and change the door
hinges according to the following steps:
⑦
1. Remove the hinge cap by twisting it off.
2. Remove the upper hexagonal head screws.
The freezer door can now be removed.
3. Remove the middle hexagonal head screws. The
refrigerator door can now be removed.
4. Remove the right side leg, attach it to the other side hole
which is positioned symmetrically.
5. Remove the left side leg, attach it to the other side hole
which was positioned symmetrically.
6. Attach the bottom hinge symmetrically to the other side of
the cabinet.
7. Remove the upper hinge plug buttons and insert them in the
holes from which the screws were removed in Step 2.
8. Remove the middle hinge plastic cover and remount it to
cover the holes from which the screws were removed in
Step 3.
9. Remove the door plug button from the top of each door
using a screwdriver and insert in the hole on the opposite
side of each door.
10. Attach the refrigerator door to the bottom hinge.
11. Rotate the middle hinge 180 degrees. Attach it to the
refrigerator door and secure it with a screw. (Do not
tighten the screw completely.)
12. Attach the upper hinge to the freezer door. Attach the
freezer to the middle hinge and use the screw to attach
the upper hinge. (Do not tighten the screw completely.)
13. The direction in which the doors open has now been
changed; however, the following points should be
checked:
A) Make sure both doors are on straight.
B) Make sure that there is no space between the door
gasket and the refrigerator unit itself when the doors
are closed.
C) Make sure that the gasket on the hinged side is not
caught between the door and the unit when the door
is opened or closed. (If the door is forced closed
when the gasket is caught, the gasket may be
damaged.)
14. After making sure that the doors are installed correctly,
tighten all the screws holding the hinges. If they are not
tightened, the doors may slip out of position or there
may be an opening between the doors and the cabinet.
15. For models with senior living handles, remove the
screws holding the handle on the door. Remove plastic
pins from the other side of the door and insert them into
the holes where the screws were removed. Re-install
the handle using the same screws that were removed
from the door handles.
ⓞ
⑨
ⓞ
⑨
⑤
⑤
ⓞ
Installing the Hinge Clip
① ② ⑫
⑧
ⓞ
⑥
④
⑪
③
Do not route high-voltage electrical cords
WARNING:
underneath the hinge clip. Only use the clip
to cover low-voltage electrical cords.
Loading...