MGA Entertainment 256571 Users manual

256571 Land Sea R/C

Installation of Batteries
Vehicle

• Open the battery cover on the top of the vehicle by using a Philips screwdriver. Insert a 6V
power pack with the positive (+) and negative (-) ends facing in the directions indicated.

• Replace the battery cover.

Controller

• Open the battery cover on the rear of controller and snap in a 9-Volt battery.

• Replace the battery cover.

Battery Precaution

• Use the special rechargeable 6 Volt power pack.

• Be careful to insert batteries following the correct polarity.

• The supply terminals are not to be short-circuited.

• Only batteries of the same or equivalent types as recommended are to be used.

• Installation of batteries should be done by adult.

To play the Land Sea R/C on Land

1. Press the On/Off switch once to turn the vehicle on, the On indicator will light up.

2. Slide the controller switch of the controller to Land Mode.

3. Press and hold the Extend button to extend the wheels unit the wheels are fully extended.

4. Use the Left & Right control sticks to control the Land Sea R/C to move forward, backward,
left turn & right turn on Land.

To play the Land Sea R/C on Sea

1. Move the Land Sea R/C to water front.

2. Slide the controller switch of the controller to Sea Mode.

3. Press and hold the Retract Button to retract the wheels unit the wheels are fully retracted.

4. Use the Left & Right control sticks to control the Land Sea R/C to move forward, backward,
left turn & right turn in water.

To Charge the Battery

1. Remove the Battery Pack from the Land Sea R/C.

2. Insert the Battery Pack to the charger with the positive (+) and negative (-) ends facing in the
directions indicated.

3. Plug the Charger to AC mains.

Remark

Modifications not authorized by the manufacturers may void users authority to operate this device.
Notes:

This equipment has been tested and found to comply with limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, these is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help