MFJ MFJ-44 User Manual
MFJ-44 SCOPE TUNING ADAPTER
MFJ-44 Scope Tuning Adapter
Thank you for purchasing the new MFJ-44 Mark and Space filter. The MFJ-44
is designed to provide Mark and Space filtering for the MFJ1278B MultiMode Data Controller. The filtered output from the MFJ-44 is used to drive a
regular test equipment oscilloscope or monitor scope. The result is an
accurate elliptical cross-hair type tuning display for a more precise method of
tuning in various amateur radio signals. Some of these signals include ASCII,
RTTY and PACTOR to name just a few. By using a monitor scope as a tuning
aid the user can tell whether the Mark and Space frequencies of the incoming
signal are high or low. The user can also tell the frequency shift of the
incoming signal.
Installation
Please follow the installation procedure carefully. This will ensure a good
installation and a better chance of no failure.
1. Remove all power connections and other cables from the MFJ-1278B. 2.
Remove the top chassis cover from the MFJ-1278B.
3. Locate the PC board mounting screw behind U16 on the MFJ-1278B
motherboard and remove it.
NOTE: DO NOT discard the screw in step #4. Set this screw aside as it
will be used later.
4. Install the 1/2" aluminum hex spacer provided into the hole where the screw
in step #4 was removed. Be sure not to cross-thread it. DO NOT overtighten this screw as it could strip the aluminum threads.
5. Locate header J15, which is just to the left of U20, XR2211
6. Align the 6-pin header plug P1 on the MFJ-44 PC with the header J15 on the
MFJ-1278B motherboard. Align PI and J15 so SP pin on the MFJ-44 PC
and the SP pin of J15 line up.
MFJ-44 SCOPE TUNING ADAPTER
Installation (Cont.)
7. Plug the MFJ-44 PC onto J15 on the MFJ-1278B motherboard. The
MFJ-44 PC will not seat fully onto J15. Be careful as to not bending any
pins on J15.
8. Locate the screw which was removed from the MFJ-1278B motherboard in
step #4.
9. Locate the mounting hole near the right rear corner of the MFJ-44 PC.
10. Secure the MFJ-44 PC with the screw removed from the MFJ-1278B in
step #4. DO NOT over-tighten the screw as you could strip the
aluminum spacer threads.
This completes the installation of the MFJ-44 PC into the MFJ-1278B. You
are now ready to align the MFJ-44 to your monitor scope.
NOTE: Before performing the MFJ-44 to Monitor Scope alignment it is a
good idea to check the calibration of the MFJ-1278B.
MFJ-44 to Monitor Scope Alignment
In this section we will align the MFJ-44 to your monitor scope. This
requires that you make the appropriate cable to connect your monitor
scope to the TTL Port connector J5. This cable is not supplied with the
MFJ-44 or the MFJ-1278B. The TTL Port connector J5 is located on the
back panel MFJ-1278B. Connect the 10-pin molex IDC plug supplied
with MFJ-1278B to one end of the cable. The MARK output is J5 pin 9
and the SPACE output in J5 pin 10. Connect the proper connectors that
will mate with your scope inputs to the other end of the cable. Once the
cable is complete connect it between your scope and J5 of the MFJ-1278B.
Connect the MARK to the output from J5 to the HORIZONTAL input on
your scope.
Loading...