MFJ MFJ-4116 User Manual

MFJ-4116 Bias-Tee

DC

RF

DC / RF

DC

RF

1-60 MHz

INTRODUCTION

The MFJ-4116 Bias-Tee is ideal for running coax to distant devices allowing them to be placed
anywhere regardless of power availability. Several MFJ products have a built in Bias-Tee, so the
DC / RF coaxial cable can be directly connected to them as well.

The MFJ-4116 Bias Tee operates on frequencies ranging from 1-60 MHz. The Bias-Tee is used
to inject DC voltage onto coaxial lines. The DC voltage is separated from the RF signal by
another MFJ-4116 on the terminating end (See Figure 1). Any standard 2.1 mm 1-50 VDC, 1
Amp maximum adapter will work.

INSTALLATION INSTRUCTIONS

1. Connect the transmitter to the “RF IN/OUT” coaxial connector on Bias-Tee 1 using a

50-ohm coaxial cable. (See Figure 1) This is the RF signal input connector.

2. Connect a DC adapter to the “DC IN\OUT” jack. This is your DC voltage input

connector.

3. If the device you are using does have a built in Bias-Tee, connect the device to the

“RF/DC OUT/IN” coaxial connector on Bias-Tee 1 using 50-ohm coaxial cable. The
device will recover the RF and DC signals.

4. If the device you are using does not have a built in Bias-Tee, connect the “RF/DC
OUT/IN” coaxial connector from Bias-Tee 1 to the “RF/DC OUT/IN” coaxial
connector on Bias-Tee 2 using a 50-ohm coaxial cable. This is your RF/DC out of Bias­Tee 1 into Bias-Tee 2 to be recovered.

5. Connect the device to the “RF IN/OUT” coaxial connector of Bias-Tee 2 using a 50­ohm coaxial cable. This is your recovered RF signal output connector.

6. Connect the device to the “DC IN\OUT” of Bias-Tee 2 using a DC adapter. This is your
recovered DC voltage output connector.

in

in

Bias-Tee

1

Figure 1: MFJ-4116 Bias-Tee Operation Diagram

Bias-Tee

2

out

out