MFJ MFJ-260CN User Manual

MFJ-260 DUMMY LOAD
The MFJ-260 Dummy load is a dry, air coooled, resistive dummy load. This resistor load is capable of dissipating RF power without the bulk or mess of oil or other coolants. It is capable of handling up to 300 Watts for a short period of time. For added convenience a derating curve is shown below and on the end plate of the dummy load.
1. Become familiar with the duty cycle derating curve so that over-heating of the resistor is avoided.
2. Connect the transmitter or amplifier to the input of the dummy load with a PL-259 connector.
NOTE:
Do not let the dummy load resistor get hot enough to glow red. If the dummy load resistor starts to glow red, turn off the transmitter immediately and allow the dummy load to cool down before touching it.
Specifications
IMPEDANCE: 50 Ohms, ± 10 %
VSWR: Max: 1.3:1, 0-650 MHz
POWER 300 Watts for 30 seconds DISSIPATION: 90 Watts continuous

DIMENSIONS:

1
227
1
1
××
2
2
′′
POWER CURVE
Derating curve for the MFJ260 Dummy Load.
2
Loading...
+ 1 hidden pages