MFJ MFJ-1835H Instruction Manual

MFJ-1835H

10,12,15,17,20 METER

HIGH POWER

COBWEB ANTENNA

INSTRUCTION MANUAL

Tel: [phone] Fax: [phone]

CAUTION: Read All Instructions

Before Operating Equipment

300 Industrial Park Road

Starkville, MS 39759 USA

COPYRIGHT 2015 MFJ Enterprises I nc .

C

Introduction

Thank you for purchasing the MFJ-1835H five band HF antenna. You new antenna is composed of
High strength material for excellent rigidly and light weight. The MFJ-1835H is compact and excellent
for restricted space or portable installations. The antenna is omnidirectional enough to not require a
rotator. It has good bandwidth and minimum SWR on all five bands. It can be mounted on tripod for
temporary locations or any mast 1-1/2 diameter or smaller for permanent installation.

Preparation

This antenna although it is not heavy, might be cumbersome for one person to handle.
It is a good idea to have a temporary mast about 6 feet off the ground to hold the antenna while you
are working on it. If you don’t have a mast available, saw horses other support can be used.
The antenna support arms can be installed on a flat surface like a garage floor if needed. The antenna
assembly will go quickly and is fairly easy but take your time anyway. As with all antennas, safety
glasses are recommended during the assembly and tuning. We don’t want you to “Poke your eye out”.
Pick a clear open spot and assemble the antenna away from other people. Do not allow children
in the assembly area. Only the people involved in the construction should be near. If you plan to
assemble the antenna over grass, be prepared to go on a lawn safari to find the hardware that you drop.
It’s not a question of if, but when you drop something. A few extra parts have been included in the parts
pack for just such a adventure. Assembly can be done by one person but when the antenna is to be
mounted or moved, plan to have a friend help. It is not wise to attempt to install any antenna without
help. Don’t rush. The more time you put into the antenna, the happier you will be with the results.

WARNING

AWAY FROM POWER LINES

Never mount or move any antenna where it can come into contact

with power lines. If this antenna comes into contact with power

lines, it can KILL you. Never mount any antenna where if it fell

it could come into contact with power lines.

KEEP THIS ANTENNA

In the box

2 mounting plates 1 mounting bracket

4 element arms 1 feed arm

5 insulators

1 matching box

Parts pack

Lots of

Nuts and Bolts

2 rolls of element wire for each band

10 12 15 17 20

Assembly

Select one of the two mounting plates. Install the mount bracket onto the plate
using four 6-32 x ½ screws and nuts. Make sure the nuts are on the bracket side

mounting
bracket
holes

4 places

Support arms

Select one of the four element arms. Install the arm between the two plates
using four 6-32 x 1 inch screws and nuts. Snug the nuts but do not tighten.
Install the remaining three in the same manner.

Make sure the plates are
turned the same way.