MFJ-1764, MFJ-1765, MFJ-1766
MFJ Dual Band (2 & 6 Meter) 5/8 Wave Super Gain Antenna
Instruction Manual
Thank you for purchasing the MFJ Dual Band 5/8 Wave Super-Gain
Antenna. This antenna is designed to operate both the 2-meter
(144 to 148 Mhz) and the 6-meter (50 to 54 Mhz) bands.
Two versions of this antenna are available:
MFJ-1764: Single 5/8 wave Super-Gain antenna. This model is
shipped partially assembled. The following parts are supplied:
2 pieces Elements
1 piece Chassis assembly
1 piece Clamp assembly
MFJ-1766: Two 5/8 wave Super-Gain antennas. This model is
shipped partially assembled. The following parts are supplied:
4 pieces Elements
2 pieces Chassis assembly
3 pieces Clamp assembly
1 piece Direct feed splitter/cable harness
MFJ-1765: Direct feed splitter/cable harness assembly. This
harness is shipped pre-assembled with mounting bracket. A
mounting clamp is also supplied. MFJ-1765 is used to feed two
5/8 wave Super-Gain antennas. It can be purchased separately
for those who have two MFJ-1764s and wish to feed both MFJ-1764s
together for additional gain.
Assembly Instructions
Refer to Figure 1 to assemble the 5/8 Wave Super-gain antenna.
1. Locate the ceramic insulators on the chassis assembly. A
screw has been installed in each insulator to hold it in place
for shipping. Hold the insulator together, carefully remove the
screw, note the location of the nuts. These nuts will be used
to install the elements.
Make sure that the flanged nut is screwed onto the element.
Note that the flange part of the nut MUST face toward the
insulator. See Figure 1.
After removing the "holding" screw, insert the element into the
insulator and through the lug on the inside. Secure the element
by screwing the other nut (taken from the "holding" screw (onto
the end of the element inside the chassis. See Figure 1.
Repeat steps 1, 2, and 3 to install the other element.
If you have purchased the MFJ-1766, you will have to assemble
another Chassis assembly. Use the same instruction as in step 1
thru 4.
Installation Instructions
MFJ-1274: Single 5/8 Wave Super-Gain Antenna
The Super-Gain antenna can be mounted on any 1" to 1-1/2"
tubular mast. The mast my be a conductive (metal) or a nonconductive material.
For optimum performance the antenna should be mounted as high as
possible. However, if the mast itself is located at a high
elevation, such as a hill or mountain, the need for a tall mast
will not be as critical.
The antenna may be mounted horizontally or vertically. The
antenna should be mounted horizontally for SSB and mounted
vertically for FM operation.
Once you have mounted the antenna, connect the feedline to the
SO-239 on the antenna chassis assembly.
MFJ-1766: Dual 5/8 wave Super-Gain antenna
If you are installing two 5/8 wave Super-Gain antennas, you may
stack each Super-Gain antenna on top of each other on the same
mast. Each antenna must be separated by a distance of 12 feet
(antenna mount-to-antenna mount). See Figure 2. You may also
install the two antennas horizontally. Again separate them by
12 feet.